Nice vid. A couple of questions if you don’t mind. Where did you get your lights at? I’m want to make the lights to work as turn signal lights as well. Would the lights you installed work as such? TIA.
@justanotherotrguy
13 күн бұрын
@abs1913 you can get them at any main truck stops. Id recommend getting some generic dual revolution lights off amazon though. You can get 10 for like $30 and they're between $15-$18 a piece at truck stops. You can run them to work as turn signals as well, just run a wire to something tied into your directionals and splice it into the mix!! Thanks for watching btw!
@abs1913
13 күн бұрын
@@justanotherotrguy thank you much. I’ve been looking at some but I like the ones you installed because they are ready to plug and play. You don’t have to be doing any termination. Thank again and keep making the vids. They help some of us for sure…. Keep trucking!!
@justanotherotrguy
13 күн бұрын
@abs1913 id honestly recommend splicing instead of the plug and plays. Theyre easier, yea. But they corrode and disconnect and stuff super easy. Every other lights ive done have been spliced and theyre holding strong. Both work, the p&p ones will eventually need to be fixed
@stephanburgess2805
5 ай бұрын
Thanks dude this helps me with my t680
@justanotherotrguy
5 ай бұрын
Absolutely!! Any time man. Hopefully you stick around!
@johndoejntify
4 ай бұрын
Do you connect this directly to the factory marker lights? Or you have to install a relay too?? I have a 2019 Cascadia and want to do this to my truck. Thanks in advance.
@justanotherotrguy
3 ай бұрын
I connected them directly to the marker lights. That way when the markers come on, they all do!
@moisesgovea6028
Жыл бұрын
Thanks for the detailed video 👍
@justanotherotrguy
Жыл бұрын
Any time!!
@elianaramirez4051
8 ай бұрын
🤷
@morty24
Жыл бұрын
KEEP EM COMIN’!
@abdulganifarah1320
4 ай бұрын
legend
@2123dgr
10 ай бұрын
How did you run auxiliary cable to visor?
@justanotherotrguy
10 ай бұрын
Connected all the aux wires in the visor lights and connected them to a 16 gauge wire from behind the center clearance light behind the cb tray. Then ran it down to the driver side pillar and through the dash (behind the steering column) to my spare (blue light) switch. Easy peasy
@2123dgr
10 ай бұрын
Perfect thank you for the information.
@justanotherotrguy
10 ай бұрын
@@2123dgr any time! Hope to see you comment on my other uploads!
@2123dgr
9 ай бұрын
Where did you get the panels?
@justanotherotrguy
9 ай бұрын
@@2123dgr bobs chrome zone in lake station indiana in the flying j parking lot
Пікірлер: 19