Hi I have a hotpoint Aquarius washer dryer wdal8640 over the last few months I have noticed that if I put it on a pre set dry program let’s say cupboard dry I come home and most of the lights are flashing but doesn’t do it on “timed drying” 2nd issue is it can take up to 45 50 mins just on final spin! as it’s constantly trying to re balance it. All the filters are clean everything sounds fine and works as it should till final spin then it all goes wrong. Sometimes it works sometimes it doesn’t….
@washingmachinetipsandhelp4350
2 жыл бұрын
Hi Colin. Re: the 40-50 minutes to finish the final spin you are spot on, it’s a balancing issue. Very annoying . I have seen it on so many machines at this stage. Regarding the drying issue, you’d have to think it is some issue with the pcb. That would be my thinking anyway.
@colinsace1
2 жыл бұрын
@@washingmachinetipsandhelp4350 thanks for you’re reply and it was only 2nd hand two years ago as I was desperate I have had hotpoint before but this one take the p*^s… and I been told it’s a pcb problem. It takes ages… and if you’re in a hurry wash and wear ? Nope doesn’t spin but goes straight on to dry 🙄😒 I have ordered a new Hoover H wash I am on budget so can’t afford a bosh or lg 😞 but can’t handle my hotpoint anymore I’ll keep in the cupboard as a spare. Lol.
@washingmachinetipsandhelp4350
2 жыл бұрын
@@colinsace1 hotpoint are not as good As hey once were unfortunately 😟 neither are Bosch or LG for that matter 😟 Hoover ain’t so bad, again not like they once were but not too bad either
@maxluta6289
Жыл бұрын
Hi, We have a problem with cold water- the washing machine does not heat water (heater and sensor in working order). I bought used one PCB (tested) for the same model but does not work. Should I update the software? Thank you
@washingmachinetipsandhelp4350
Жыл бұрын
Hi. Does the replacement PCB do what the previous PCB did, IE does it do everything just not heat the water ?
@iainsutherland5728
2 жыл бұрын
Hi mate I’ve got the fault f01 showing on my machine do you think it will be the same problem Thanks
@washingmachinetipsandhelp4350
2 жыл бұрын
Hi Iain, Is your Machine a hotpoint too ?if it is F01 does indicate a PCB Issue unfortunately. However you can PCB’s on eBay for €30-40 euro and a pretty simple to change. If you are ordering one do make sure it looks the same as your one as sometimes even though they are the same model PCB Boards can vary. If you need any advice on anything be sure to ask 👍
Пікірлер: 10