Woodturning: Punky Flame Boxelder - Shear Scraping for the Best Finish
I started this project right before I had shoulder surgery, like the night before I had surgery 🤣
I have a bunch of this flame boxelder - it was a little punky to start with and it is only getting punkier. I used the shear scraping technique to help get rid of the tear out and finished the piece about 6 weeks after I’d started it. I talk about shear scraping and recommend the following videos by the pros for the exact definition and proper technique:
Lyle Jamieson
• Lyle on Sheer Scraping...
Reed Gray aka RoboHippy
• SHEAR SCRAPING by Reed...
I finished the piece with General Finishes Arm-R-Seal Gloss and it’s not my favorite - it took 3 coats of the finish plus Brad’s Sanding Paste and buffing with the Beall Tripoli and White Diamond wheels to get it to a point I was satisfied. Using Brad’s Tung Wax or Tung Honey is much faster, looks just as good, and is food safe so I’ll likely not use the GF again.
DISCLAIMER: My videos are not meant to be instructional videos. I am still learning and am in no way trying to present a teaching video - my channel is classified as Entertainment. Do I hope you get something useful? Sure! Do I think you can learn from my successes, failures, and mistakes? Yep!
However, you are responsible for your own safety! Wearing long sleeves, gloves, or jewelry around machinery is not recommended and can be dangerous!
Ways you can help support me and keep videos coming:
Subscribe, Like, Comment, Share 😊
PayPal Tip Jar:
www.paypal.com....
Become a Patron:
/ lisaramlow
Some of these links are affiliate links, which means if you use them to make purchases, I may earn a small commission from that company. This doesn’t cost you anything and is a great way to help support my channel and keep videos coming.
Starbond Adhesives:
Promo Code LISA10
www.starbond.c...
Promo Code RAMLOW10
www.etsy.com/s...
www.triedandtr...
bealltool.com/...
Негізгі бет Woodturning: Punky Flame Boxelder - Shear Scraping for the Best Finish
Пікірлер: 73