Thanks for that video very helpful you didn't put the diverter valve back in though in the 10 minutes lol . This is a better way to do it than cut the cold water pipe as you can also change the seals doing it this way .
@BoilerMend
8 ай бұрын
Hi. Thanks for your message. This is the correct way, in my opinion 🤓. As, cutting the pipe option may not, always be feasible. Especially, if the pipework under the boiler, is not neatly done, or is a "spaghetti Junction", as I call it 😉
@umark6695
Жыл бұрын
That was quick. Wouldn't mind some more diagnosis/repair videos.
@user-li8gr8ur8l
5 ай бұрын
That was awesome buddy❤ . Thank you
@BoilerMend
5 ай бұрын
Thanks 👍
@mansoorraza9652
Жыл бұрын
Great job 👏 well done mate.
@mohammedarfan7109
Жыл бұрын
Brilliant Job
@rickd6421
Жыл бұрын
Awesome video mate. Takes me longer than 10 mins. Last one i did had 22mm return pipe wedged behind plate hex so i had to loosen flow manifold and pull it forward hahaha
@BoilerMend
Жыл бұрын
That's the worse one.. 😒
@PeteLeeworthy
7 ай бұрын
Used this method today brilliant 👍🏻
@BoilerMend
7 ай бұрын
Lovely 🫶
@douglaughton7626
Жыл бұрын
I’m sure I’ve replaced a plate on this model, if not definitely the older model, where I cut out the hot pipe outlet and replaced the plate without removing the pump
@BoilerMend
9 ай бұрын
Well. One might need to cut a few more pipes, on top of the hot water only, if the piping under the boiler's been done by Plop the Plumber😉
@hamzaparvais3948
10 ай бұрын
Excellent thanks learned a lot
@charliewillis8527
Жыл бұрын
You must work for Worcester ther the only ones that have to work that quick lol
@BoilerMend
Жыл бұрын
😬🙄
@khurassan
9 ай бұрын
well done
@ianbrooks6816
Жыл бұрын
U good job!
@mohammednazir6268
4 ай бұрын
I have fault on worcester 30i erp D4 341 temp sensor fault, does it need new sensor or fault is elswhere, new to breakdowns
@BoilerMend
4 ай бұрын
Hi. This fault points to a faulty primary sensor as well as a few other possible faults. This fault is pointing to an issue, which is causing the boiler, to Not be able to dissipate/ circulate the heat it is generating. Can be due to a wiring fault, faulty pump, incorrectly positioned Motorized/ mechanical valve, dirty system pipework, radiators or even boiler's main heat exchanger.
Пікірлер: 23