That's amazing. You guys really need to allow your engineers out once in a while 🤣
@DicePunk
2 жыл бұрын
This is the future!
@hani5235
Жыл бұрын
that looks nice!!! are you using fdm 3d printer??
@teccotoys
Жыл бұрын
Thank you! No, all prints are done on Elegoo Mars3 resin printers using Resione resins.
@MarcosHidalgo
2 жыл бұрын
This is great as backup if you don't have M2 screws at hand. I usually have a box with different sizes of M2 and M3 (sizes used for DIY prited gadgets) nylon screws and nuts in black. They're a "must have" and are inexpensive in aliexpress.
@johanneswetzel3023
2 жыл бұрын
This is amazing!
@SSJMRJ
2 жыл бұрын
So flippin cool
@seanswader7425
2 жыл бұрын
Neat stuff
@spencersmith3618
2 жыл бұрын
Will this model be printable on a small bed printer like the photon mono 4k
@teccotoys
2 жыл бұрын
yes. It's basically an action figure/vehicle, so it comes in all separate parts that have to be assembled after printing. Even with small print beds, you can print a lot of parts in one go.
Пікірлер: 12