For those of you saying it's cheaper to buy a dedicated bearing puller than to modify imagine this: You are in a remote Jobsite no hardware stores around and you have a vice grip and a welder - what do you do? Drive across state line for 3 hours or improvise one? I been in situations where I needed a specialty tool in a hurry and hard to make one from scratch. These videos are very useful. According to your logic there is no need of buying kitchen appliances and groceries when you can buy a 99cents hamburger from Mcdonald. Dumb!!!!
@despicable-mi
5 жыл бұрын
A bearing puller cost Rs. 120/- And a locking plier cost Rs 450/-. You are genius 😚
@periyasamy7330
3 жыл бұрын
தயவு
@CreativeToolMistry
6 жыл бұрын
Nice video
@javierdiaz17
6 жыл бұрын
👍👍👍👍👍👍👍👍👍👍👍👍
@Peter-.H
5 жыл бұрын
Brilliant 👍👍👍
@MrNovruz
6 жыл бұрын
Nice work
@slhansa9149
6 жыл бұрын
Ela aiya..
@CreativeToolMistry
6 жыл бұрын
Please help me
@slsandaofficial
6 жыл бұрын
help ((37help))ok
@pedro20329
6 жыл бұрын
👍👍👍, great master !!!.
@rasikaprasanna2274
6 жыл бұрын
Good
@novruzkavkaz
6 жыл бұрын
Nice work !!!
@mohammedmohan1401
6 жыл бұрын
done
@den_polansky
6 жыл бұрын
А обычным съемником подшипник не снимается чтоль?
@ОлегГромов-ь2ю
6 жыл бұрын
Когда коту делать не хуй , он яйца лижет!
@sanyausm1980
6 жыл бұрын
Обычный для шаровой пошел бы, так еще и уебал инструмент
@fethiberrekama5843
6 жыл бұрын
Très belle vidéos merci beaucoup c'est très bien
@busytirex2366
5 жыл бұрын
time and vise gips wasted
@stevehall5000
Жыл бұрын
lame long clik baig vid, watched 2x speed and still bored
Пікірлер: 27