It's so much easier with a heat gun and use the tool to stretch and tuck the wrap around the emblem, before cutting around the emblem.
@HowToHeaven
3 жыл бұрын
I agree on really curved surfaces, but this was a piece of cake. Thanks for watching my videos!
@RedCdot
11 ай бұрын
Can you install RGB on the badge without messing the sensor up
@michaell5026
8 ай бұрын
Wondering if you can help me. I just bought some black plastic emblems from Ebay for my 2024 Camry. The Y and the SE didnt fully stick. The ends are a little out and i can see the original chrome a tiny bit. Im afraid it wont stick over time. Any suggestions?
@HowToHeaven
7 ай бұрын
3m double sided sticky tape! Not a generic tape!
@dp-qw4ji
2 жыл бұрын
The problem is, the front emblem has sensors behind it, you could loose accuracy . I would not recommend it to do this
@HowToHeaven
2 жыл бұрын
Drove the car for months, and NO ISSUES with the radar. Thanks for watching
@crystamason3519
Жыл бұрын
I was wondering about that too. Thank for updating
@petermuniz9296
Жыл бұрын
Dose this hide the sensors
@HowToHeaven
Жыл бұрын
No, the radar cruise works as normal after this wrap.
@santosf1107
2 жыл бұрын
Now you have no emblem😂 I used smoke tail film and it look better you can still se the toyota logo👍
@HowToHeaven
2 жыл бұрын
Yes, and that was the look that I wanted!
@highlandreelvsbricksandmor9996
2 жыл бұрын
@@HowToHeaven where did you get the black out wrap? Please post link
@HowToHeaven
2 жыл бұрын
@@highlandreelvsbricksandmor9996 It's from Amazon, it was a brand called Vivid (sorry no link), but it was too thick to be used for parts with a lot of detail, but great for emblems and gas caps. Hope that helps.
@HowToHeaven
2 жыл бұрын
Thanks Santos, but that was actually the intent. The car has been debadged, except for the ONE emblem in the rear! Thanks for watching
@Pamsophydee
2 жыл бұрын
Question, how would one go about removing the wrap?
@HowToHeaven
2 жыл бұрын
It's pretty easy to just peel it off. Sometimes there is residue and you can use a product called "Goo Gone" at Homedepot. Thanks for watching my videos! HowToHeaven
@Pamsophydee
2 жыл бұрын
@@HowToHeaven It worked, thanks appreciate it!!!
@HowToHeaven
2 жыл бұрын
@@Pamsophydee You are welcome.
@jeremysamson4813
Жыл бұрын
Ummmm. .......I would have cut out the entire emblem.. that doesn't look good...
@HowToHeaven
Жыл бұрын
Ok, go ahead and do that and then make a video and we'll let you know what we think...
Пікірлер: 21