Part 3 of 3: kzitem.info/news/bejne/ymiKz3ucjZd7daQ
@electroelectronics4513
4 ай бұрын
Thanks very helpful video🙏
@electroelectronics4513
4 ай бұрын
Make a video fuji t2 display board
@T2D.SteveArcs
11 ай бұрын
I think you can just ground the start stop pin iirc , i played with one from a laser printer a long time ago
@KaizerPowerElectronicsDk
11 ай бұрын
I am positive, that I did try to ground it. On the other hand, I could be completely mistaken.
@T2D.SteveArcs
11 ай бұрын
@@KaizerPowerElectronicsDk I may be miss remembering aswel mate.. cool video anyway, its good to show people this stuff...👍👍👍
@amitkumarsingh5783
11 ай бұрын
thanks for video.
@june9713
7 ай бұрын
Thanks for your greate video. I have one question, Any way to know ho to read output of laser by sensor? Now I cleary understand how to make laser line,but I still dont undetstand how to read it at last. Thank you so much your greate greate video.
@KaizerPowerElectronicsDk
7 ай бұрын
From how the x-ray image is converted from a "single pixel exposure" into a gray scale image, I would guess its something like a 0-255 value per pixel, to determine the gray scale.
@roentgen226
11 ай бұрын
Jeg fik en lübcke 10A 3 phase Motorstyret variac der ligner din rigtig meget inden i
@KaizerPowerElectronicsDk
11 ай бұрын
Jeg måtte sælge min 25A motorstyrede 3 fasede. Den tog alt for meget plads :)
@en2oh
5 ай бұрын
Is there a part /
@en2oh
5 ай бұрын
Part 3? 😉
@KaizerPowerElectronicsDk
5 ай бұрын
yes! Part 3 was just named a bit different :o kzitem.info/news/bejne/ymiKz3ucjZd7daQ
Пікірлер: 14