You have got to be absolutely kidding 😂 After getting a glimpse at your reg number I thought no bloody way!!! I now own this very car, I thought it looked familiar when looking at it 😂
@kieferste
Жыл бұрын
Do you live near wingate I'm sure I've seen it I've done a hell of alot of work to that car
@sbr1160
Жыл бұрын
@@kieferste yes pal, I'd actually like to pick your brain on it if there's a way of contacting you direct
@kieferste
Жыл бұрын
Yes mate email me your number and let me know when you've done it and I'll call you when I get a min it's stevo188204@outlook.com
@jirkarutar1052
Жыл бұрын
Uaau, kompliment, gud Job, Georg from Prag ❤ very nice
@tommaser
Жыл бұрын
Good job mate! I did the front one today and was wondering how to reach that rear one…🙈😅🔧 You saved me.
@kieferste
Жыл бұрын
No problem 😊
@avgavg001
13 күн бұрын
Thank you for the informative video. Do you happen to remember which brand of mounts you used?
@willmill409
2 жыл бұрын
The rear one looks easy on this engine but I have a 3.2 6 cylinder and u can't even see the bottom nut for rear engine mount
@kieferste
2 жыл бұрын
It's not too bad on this engine but to be honest I haven't done the 3.2 so I can't help you my friend
@samueltellotena2473
2 жыл бұрын
god work :D
@badrzain4106
3 жыл бұрын
Thanks for an awesome video, Did your car have vibration on idle only or even while driving? Have the vibration caused any loss in power while driving?
@kieferste
3 жыл бұрын
While driving it was accelerating most of the vibration was there turning left it would not vibrate but turning right it would
@badrzain4106
3 жыл бұрын
@@kieferste thanks for your reply, I'm facing kind of the same issue, but it also affected the power of the engine, I had to ride the car back home for about 100 km and that was noticeable that the power of the engine reduced. Even I couldn't drive faster than 120 km/h. I'm wondering if that is because of the engine mounting? Any idea?
@kieferste
3 жыл бұрын
You may have a vacuum leak the engine mounts work on vacuum but it would only affect the power on take off once the revs are up it closes off the vacuum to the mounts I've made a video on the vacuum system hope that helps other than that you would need to scan the car see what codes are there
@malicetnik1
2 жыл бұрын
Thanks a lot for for the Video. And the Torque Mount ist empty 😉
@abbashussain6390
3 жыл бұрын
Thanks 👍
@StevenToddScholl
2 жыл бұрын
nice job!
@thuperthexthy3659
Жыл бұрын
So you didnt have to remove the front mount screw to jack it up?
@prokhorlevada3701
Жыл бұрын
Thanks!!!
@andrewnewton5893
Жыл бұрын
I need to do this as swapped gear box mount as bush had gone started it up and it got horrid vibration so ill assume i need to replace these lol 😆
@henrikloiske8572
Жыл бұрын
Did you check out your front engine mount, its almost similar to the back one
@kieferste
Жыл бұрын
Yes I checked and tested for leaks it looked like it had been replaced that's why I only replaced the rear
@henrikloiske8572
Жыл бұрын
@@kieferste How did you test the rear engine mount
@kieferste
Жыл бұрын
@@henrikloiske8572 with a vacuum gauge it should hold steady vacuum at idle
@alexbowie6316
2 жыл бұрын
Good work! Bet you saved a bit with Febi mounts over the Volvo ones?
@kieferste
2 жыл бұрын
Yeah I tried a corteco one 1st and it was rough the vibration was terrible so I took it back and swapped it
@peterstayne3765
Жыл бұрын
@@kieferste Corteco is what Volvo use genuine mounts
@Umrao1989
7 ай бұрын
@@peterstayne3765are you sure about corteco? Wasnt IT lemforder?
@peterstayne3765
7 ай бұрын
@@Umrao1989 100% sure
@bennyblanco4651
8 ай бұрын
You talk to much and get to work comon
@jorgesantos6181
7 ай бұрын
What year is your xc90?
@kieferste
7 ай бұрын
It was a 2004
@NorthdownAngler
2 жыл бұрын
Is it a D5? Or a T??
@kieferste
2 жыл бұрын
D5 mate
@NorthdownAngler
2 жыл бұрын
@@kieferste cheers mate ill get the bit ordered n changed I've a wee bit of vib through the steering wheel. So hoping this will square it away.
@kieferste
2 жыл бұрын
Make sure it's not a track rod end or lower ball joint jack the car up so wheel is off the floor move side to side up and down with your hands on the wheel should be no movement you'll know what I mean if you feel it also check drive shaft from underneath the car push it up and down should be no movement 😉
@NorthdownAngler
2 жыл бұрын
@@kieferste will do indeed. Thank so much for taking the time to help. Its really appreciated 😎
@cockatoodanish2899
2 жыл бұрын
Hi mate seems like your up north I’m from newcastle I’ve got a xc90 and need some work doing could you please get in touch with me??? Many thanks
@kieferste
2 жыл бұрын
Yes mate what's up
@cockatoodanish2899
2 жыл бұрын
Thanks for replying basically I’ve bought a XC90 on a 11 plate and from time to time the car vibrates when driving also foot brake doesn’t work
@kieferste
2 жыл бұрын
The vibration could be many things could be a misfire engine mounts drive shaft or propshaft if its an auto could be the torque converter or even a tyre I need to know when the vibration starts also the foot brake pulls a scissor to push the shoes in the rear discs they seize you would need to remove the rear discs to see I'm doing one at the weekend I'll make a vid on it
@cockatoodanish2899
2 жыл бұрын
@@kieferste where abouts are you based?
@cockatoodanish2899
2 жыл бұрын
@@kieferste where abouts are you based please I can bring it and show you?
Пікірлер: 51