XIKAR Allume Lighters
The all new Allume is a sleek, sexy and stylish single flame lighter. Don't let it's small size fool you, this lighter has been engineered for performance, strength and dependability. Its small and durable body style fits comfortably in the hand and easily slides into your jacket or pants pocket.
XIKAR is growing the Allume family with the all new Allume Single Double and Triple. These additions are sleek, stylish and powerful jet flame lighters. They have been engineered for performance, strength and dependability. The Allume double and triple give you the power you need and the performance you want.
Instructions for Use
Lighters: XIKAR Lighter Ignited
IGNITING THE LIGHTER
A simple push on the ignition switch ignites a powerful
flame over 2,000 degrees. This flame can be nearly invisible in
bright light, so proper care is recommended.
TAKE CARE NOT TO TOUCH THE LIGHTER TOP AFTER IGNITION.
To avoid heat buildup, do not use in any situation that would
require a continuous flame for more than 10 seconds. The lighter
may become too hot and cause harm to the lighter and/or the user.
EXTINGUISHING THE FLAME
Releasing pressure from the ignition button of the lighter
immediately extinguishes the flame by stopping fuel flow.
If flame continues, the flame level is set too high and should be
adjusted by turning the adjustment wheel on the bottom of the
lighter towards the (-) position.
ADJUSTING FLAME LEVEL
Turn the fuel adjustment wheel on the bottom of the lighter
towards the (+) mark to increase the flame and turn the wheel
towards the (-) to decrease the flame to achieve a desired height.
FILLING AND RE-FILLING LIGHTERLighter Bleeding with XIKAR MTX Tool
Release all tank pressure by pressing on the inlet valve with a small
screwdriver or a XIKAR MTX Multi Tool bleeder (shown). Hold the
lighter vertical while bleeding valve. Repeat this several times until all
fuel/ gas pressure is released.
Set flame adjustment to lowest setting (-).
Turn lighter in upside down position and insert butane tank tip directly
on the fuel valve. Do not shake the can of butane! This increases the amount
of propellent in the mixture that goes into the lighter, and should not be done.
Press down firmly for about 5 seconds.
Before igniting lighter, wait 3-4 minutes. This allows excess butane to
evaporate and gas inside lighter to reach room temperature.
Set flame level to desired height by turning flame adjuster wheel.
Негізгі бет Тәжірибелік нұсқаулар және стиль XIKAR Allume Single Torch Lighter Review
Пікірлер: 4