on the solinoid what side does the extra ring go on?
@IDVDalot
2 ай бұрын
is there another video showing the result?
@albertsikorsky1186
2 ай бұрын
That looks like a xl800 not a go800 how I no it’s the decals I own a xl 800 since 2001 the decals are green the xl800 is green Yamaha called it forest green on that model back in 2001 i thought I help only nice video to😁👍
@865-customz
2 ай бұрын
@@albertsikorsky1186 You are correct The body is an xl, same engine and electronics - 66e.
@gdj8013
11 ай бұрын
Man I thought that engine was done when you said low compression. Didn’t know that rings would stick after sitting awhile. Good to know because I’ve got an xlt1200.
@ernestl709
Ай бұрын
What if you feel&hear buzzing coming from the fuse box.?
@865-customz
Ай бұрын
@@ernestl709 Dead / bad battery.
@ernestl709
Ай бұрын
@@865-customz it’s a new battery but I’ll change it for a new one
@865-customz
Ай бұрын
@@ernestl709 If the other battery does the same thing / tighten all the connections on the battery and solenoid. A loose wire could cause it but usually the battery.
@manuelmitc3994
Жыл бұрын
I got a yamaha gp800 and I have an ignition problem, selenoid clicking , but what I see is that it makes a different noise than the one in the video, Do I have to check something else first or do I definitely have to replace the solenoid?
@865-customz
Жыл бұрын
Use a test light or volt meter to check for 12 volts. Hook a volt meter to the ground and the positive to the primary power wire on the solenoid there will be 2. One is constant 12v the other side will show 12v once the start button is pushed. If there is no voltage once the start button is pushed the solenoid is bad. If it shows 12v then the starter is bad or engine is locked.
@johniepointer8236
2 жыл бұрын
Good Job Jake!!
@chrisford3513
Жыл бұрын
140lb psi one one an 60 on the other it's not goin to run
@865-customz
Жыл бұрын
No it will not run on 60 psi.
@Xprototype12x
Жыл бұрын
Got a 98 gp800 and it runs fine but just started not revving up to power it will start and put around but if you pull on throttle it will only go like half of that. The impeller is not jammed up any idea?
@865-customz
Жыл бұрын
is the engine erving to full rpm and the ski just doesn’t go above half speed ? or does the rpm’s not increase.
@Xprototype12x
Жыл бұрын
@@865-customz it won’t rev to full rpm it was fine last season then Al of a sudden it won’t rev up full rpm to pick up speed
@865-customz
Жыл бұрын
Check and see if the power-valve motor is turning the pv wheel while revving the engine. It could also be a carburetor issue. unfortunately sever things can cause that.
Пікірлер: 19