My RD400 is a big bore and it's insane. My carbs are TM 32s that are tuned lean for them but not the motor. Nice job on the build.
@healthylivingforyou3104
Жыл бұрын
Nice how the clutch is visible, I've never seen that on RD before, Daytona single head. Nice clean engine like brand new. 👍
@supertunesupertune
Жыл бұрын
Glad to see you caught the seal backwards. Another Note: You don't want the resleeve RD aircooled cylinders, You can physically do it but any aftermarket sleeve is totally round and will choke off the transfers really bad losing power. The OEM cast in sleeves are cast thinner at the transfers to keep the ports large.
@rechargegarage8705
Жыл бұрын
Thanks for the advice on that let’s just hope I never blow it up and in the mean time I’ll look for a good set of OEM cylinders. 👍
@m1a1hm
Жыл бұрын
Great job on the RD engine. I got a 79Daytona I need to get back on the road.
@adolfshitler
Жыл бұрын
If you need bigger pistons in the future TZ750 single ring pistons "if you can get them" take the capacity out to 440. I know because i did this back in the 80's. Just boring it out was the only modification needed, straight in apart from that.
@rechargegarage8705
Жыл бұрын
Thanks for the info, good to know some of the hot mods done back in the day.👍
@adolfshitler
Жыл бұрын
@@rechargegarage8705 I also ran TZ350E expansion chambers. Power band 8-12
@KensGarage1
Жыл бұрын
Nice video. Digging the clutch cover mod.
@rechargegarage8705
Жыл бұрын
Thanks Ken.
@markaddy53
Жыл бұрын
great job lad keep it going
@rechargegarage8705
Жыл бұрын
Thanks Mark, I was a bit disappointed I didn’t record the clutch assembly and primary gear fitting but oh well.
@OVVMtoddspurrell
Жыл бұрын
I enjoyed your video. I’m thinking about putting a glass cover on mine also. Can’t decide between black or aluminum colour yet.
@rechargegarage8705
Жыл бұрын
Hi Todd I’m glad you enjoyed it and that I had some inspiration for you to do the same, I think they look cool myself. Cheers.
@naserahmed867
8 ай бұрын
I have a question sir My question is that did you use Yamaha banshee pistons?
@rechargegarage8705
8 ай бұрын
Hi there, yes I did they were aftermarket Pro-x piston kits to suit RD400 but it said on the box also fits YFZ350. Cheers
@simonhelms9222
Жыл бұрын
New camera chief ?
@johnross6691
Жыл бұрын
Where did you source the site glass cover from I would like to do the same
@rechargegarage8705
Жыл бұрын
Hi John I purchased it from eBay it’s a UK manufacturing mob that sells them. Cheers
Пікірлер: 19