Hats off to you sir! Just found last night your video, and used your tip to fix my HTR 5660 which Is identical to the one you repaired on the video, now, it's working fine, at the first shot, thank you again.
@Mascotal
Ай бұрын
Just sent mine to the recycler for that very problem.
@freddytaleb1068
10 ай бұрын
hello what was the default regulator ??
@luigi5534
3 ай бұрын
f9nk90z gk0yp vw chn 046 this is the name of my component, can you tell me how to find a replacement for it
@SunilMaxwell-kl8nw
Ай бұрын
Thankyou❤
@jeffmunger
10 ай бұрын
Toral POS do not buy. Im returning this POS, Do not buy a Yamaha reciever.
@TonyBourdier
4 ай бұрын
Yes but I didn't see the fix. I would have to pass this video on a different app to see if I can slow it down. Too fast to teach anyone. Sorry
@bpalpha
2 ай бұрын
I wonder how many of these, or other receivers, end up in land fills with such minor issues. Good to see this nice unit fixed.
@wop3994
Жыл бұрын
i have the same issue, is there somewhere i can take mine to get fixed?
@mrrcomp
11 ай бұрын
hi I have a rx-430 with similar problem; Being a newbie which legs of the regulators do you check on?
@lewisse5
11 ай бұрын
Im checking the input(1) and output(3) pins. If there is power on the input, but nothing on the output, then it is most likely the regulator the problem.
My YAMAHA HTR 3066 Showing "DC PRT : 253H" error. Some times it's shows 249h, 252h errors. And shutdown after 3-4 seconds. What are the possible problems.. is it a capacitor leakage or any short ?
@skabdulmtr2000
Жыл бұрын
Hello sir good morning I am from India i like to buy this av receiver how can I buy this av receiver i need 7.1 and 2 also
@gampaha1861
7 ай бұрын
Nice. great explain. I have a problem with Rx v870 amp get in to protection mode as soon as power on. By disconnecting the rear amp section same results. All the solder joints, caps, and relays looks good to me. in side is clean too. can you please help me out? thank you
@djkrell
6 ай бұрын
I have this same issue did you find a solution?
@allmarphil
Жыл бұрын
see you in the next one 👌
@FeedScrn
Жыл бұрын
Nice fix. Thanks for posting.
@rodneyclinton1751
Жыл бұрын
Q why protect mode ,but does not protect it
@lewisse5
Жыл бұрын
Its protecting other components from being damaged due to the failed part
@samwil0_9
Жыл бұрын
Strangely looks like mine...
@lewisse5
Жыл бұрын
🤔
@prasantadhikari5117
Жыл бұрын
Can you show how to connect all the 5 speakers (2 front, 1 central, 2 rear and a subwoofer). It is so confusing.
@nickfatsis9607
Жыл бұрын
Just follow what it says on the back of your amp, you'll have front R, front L and so on.
@ssanjayb5785
Жыл бұрын
Hi , nice one. I have the same issue. Where did you buy the regulator from ?
@lewisse5
Жыл бұрын
Digikey
@Dickgoodbody
Жыл бұрын
thanks for this... how do you adjust the speaker balance on one of these as running in stereo mode but 1 speaker is louder than the other.. went through the menu but can't see any setting for this adjustment [balance - left / right]
@lewisse5
Жыл бұрын
Sorry, but I dont know. I haven't had that issue before.
Пікірлер: 28