Lube lube lube. That wristpin bushing probably got smoked on startup. Great job on build, just need to use that lube. 👍
@Evadingmoto
7 ай бұрын
Does the wrist look bushing (the bronze part one in the rod) does it spin? (Mine does)
@devshewitt4809
2 жыл бұрын
You supposed to push on ring with piston before checking gap to get good square fit
@fishingman5977
Жыл бұрын
Super 👍
@donaldvagi8150
8 ай бұрын
What was the compression for the piston I’m getting ready to put a 11:1 in mine
@vrr6513
8 ай бұрын
I think that is what it was
@benatkinson2775
2 жыл бұрын
You need to learn how to install the rings on the piston, you shouldn't open both ends of the ring and force it on. You start with one end and walk it round.
@vrr6513
2 жыл бұрын
Thanks for the advise!
@robbiemoore8905
2 жыл бұрын
Are the head bolts all the same or do you have to put them in the right spots
@Detailing849
Жыл бұрын
When you were measuring the piston ring end gap was the 0.20 to 0.40 in thousands of an inch
@vrr6513
Жыл бұрын
I think so , hard to remember this was over a year ago you might have to check a Manuel
@Detailing849
Жыл бұрын
Ok thank you 👍
@Alex-kz4ro
Жыл бұрын
Tell me, please, the tightening torque of the cylinder head, so as not to break the thread, what is the distance of the thermal gap between the piston and the head? Thanks yamaha raptor 350
@frontlinemedia4270
2 жыл бұрын
It would be helpful to lube the bolts before install and torquing
@vrr6513
2 жыл бұрын
Thanks for the advice!
@frontlinemedia4270
2 жыл бұрын
@@vrr6513 thanks for showing the timing marks as I might be working on one of these
@benatkinson2775
2 жыл бұрын
Not lube. Antiseize. Its not the same thing. If you lube it it can come loose.. you should clean bolt threads and put on some antiseize.
@Brian-my3gd
9 ай бұрын
Did you have to pull the head back off and reposition that timing chain guide?
@devshewitt4809
2 жыл бұрын
Do not listen to this he’s not pre lubing nothing sir you need to start video with disclaimer
@vrr6513
2 жыл бұрын
everthing was prelubed apon assembly
@devshewitt4809
2 жыл бұрын
@@vrr6513 no it’s not clear in video you used no lube on piston at all putting on rod bam dry start
@michaelshaffer9305
2 жыл бұрын
It’ll be ok😂 if you gonna bitch then make your own video
Пікірлер: 22