In this video, we will show a special way to retime the balance shaft so that you don't have to remove the sump. Parts fitted on the car yd25.com.au/index.php/services...
Thanks mate, this method worked perfectly for me. Engine sounds smooth as.
@kevindavidraath2920
2 жыл бұрын
Thank you. Best video. .
@carldean322
2 жыл бұрын
not all heros wear capes! legend
@TheMrthiagox
2 жыл бұрын
Well done!!
@isakk23
7 ай бұрын
Obrigado abraços do Brasil,ninguém por. Aqui teve essa boa vontade de ensinar esse passo a passo.
@bentaher1486
11 ай бұрын
thanks ..very helpfull
@juicey5195
2 жыл бұрын
At the end where your painted line lines up with the two dots above, why is there a factory dot on the gear that’s two teeth away from your painted line? And is that where it should have been set from factory? Thanks
@paulsimpson2232
Жыл бұрын
@YD25 what's the answer to this question please
@mompatimase167
Жыл бұрын
These engines are stupidly easy to time and I'd have thought you time by the dots as well.
@MonsterWare
Жыл бұрын
@@paulsimpson2232 It's not lined up properly...Have to keep rotating until it does..then there are 2 gears on the back of the balance shaft with the sump off that have timing marks that should also line up if done correctly...This video is incorrect
@blakevickers6007
5 ай бұрын
have a think about what hes doing... you can do it like this...or pull the balance shaft assembly off...with the engine out to line the balance shaft gear mark to the balance shaft idler dots.@@mompatimase167
@aarone8013
4 ай бұрын
Sooooo what is the deal with the dot 'supposed' to be between the 2 dots on the crank cog? I have had to cajole one back to time before without removing the sump - its tricky but not impossible.
@AdventureHunter4x4
Жыл бұрын
Do you have to rotate the small gear to a certain point before you mark the first tooth or it doesn't matter as long as it matches the factory mark on the gear?
@yd2532
Жыл бұрын
Doesn't matter
@conmanumber1
9 ай бұрын
Is this the 2012 Nissan Navara D40 St-X Spanish built?.
@MrBillgiles
2 жыл бұрын
Great video, what is the purpose of the scissor gear?
@yd2532
2 жыл бұрын
It puts tension on the gears to stop gear roll over noise
@MrBillgiles
2 жыл бұрын
@@yd2532 Thanks!
@ngasilingowe8375
2 жыл бұрын
Helo. Could you please share where I can get the special pin used to lock the gear
@yd2532
2 жыл бұрын
We make them. You can use an Allen key instead.
@ngasilingowe8375
2 жыл бұрын
Ok. Thank you for your repply. The engine is still in the vehicle. With allen key its difficult to get it correct with the balance gear. If you can share dimensions of the pin please. Or if I can buy one from you. I am in East africa, Tanzania
@yd2532
2 жыл бұрын
@@ngasilingowe8375 freight would be too expensive from Australia. Send me an email and I’ll get a measurement when I’m in the office.
Пікірлер: 29