I have pulled brand new yokes & components from Dana Spicer boxes that had run out every which way you could imagine. Step 1. Chuck in lathe and spin. Observe all critical points.
@The1andonlyDMFH
10 ай бұрын
Bent output shaft
@TriStarGearhead
10 ай бұрын
I second bent output shaft, I await your result
@shortattentionspangarage1312
9 ай бұрын
The output shaft itself does the same thing. I just put the yolk on there to illustrate the movement. I really wish I'd have used some V-blocks and mic'd the shaft when I did the whole T5 rebuilt. Live and learn...
@shortattentionspangarage1312
9 ай бұрын
Thanks for the replies everyone. Looks like I'm tearing the trans apart again. This time I'm going with a G-Force mainshaft and gearset.
@ccarlock8537
10 ай бұрын
Well U joints like that travel in elliptical path but with either splines loose or not enough terth depth engagement can see the wobble instead of then the force into trans then trans mount taking up thst wobble so wont see it do that
@M21-w1y
10 ай бұрын
Thinking the yoke is not engaging the trans deep enough 🤷♂️
@ccarlock8537
10 ай бұрын
Yep
@jeremypike9153
10 ай бұрын
Had a truck awhile back that was doing the same thing. A worn output shaft bushing in the transmission can allow it to wobble too.
@shortattentionspangarage1312
9 ай бұрын
Yes it is. This is a Cobra, with a 10" driveshaft.
@shortattentionspangarage1312
9 ай бұрын
@@jeremypike9153 I agree, but this eccentricity is consistent in a circular pattern. Also, when I have the driveshaft off the output shaft has zero play.
@philippetays4263
10 ай бұрын
that ecentric wobble should not be there, what is wrong
@nunyafb1440
10 ай бұрын
Take the yoke off, spin out put on trans see if it wobbles, if not, remove u joint put yoke back on trans, Spin. Keep going till you find problem.
@shortattentionspangarage1312
9 ай бұрын
It does. This was just easier to get a video of considering it's fully installed in the Cobra.
Пікірлер: 15