I just installed this vise. Thanks for the information. There is a hole drilled through the end of one of the guide rods. If you slide a cotter or hitch pin through it, you now have stop that will prevent opening the vise too far. Nice heavy vise. I like it.
@JoePalumbo221
3 жыл бұрын
I'm getting this vise. Thanks for the walk through.
@stormbytes
6 жыл бұрын
Very down to earth and practical (and helpful!). Will be picking up this vise. Wanted a simple, cheap and straight forward mounting solution (adapted to whatever bench). Thanks
@halconperegrino5717
Жыл бұрын
Thanks for sharing your experiences, now I know what vice to buy for my table.
@evetsegap
4 жыл бұрын
Thanks for putting out there. Nice Job!
@freudeamfahrenm5
2 жыл бұрын
Thanks for the review!
@thetruth5366
3 жыл бұрын
Have you tried to take the black hollow pin out to see the construction of the vise? All Yost vises have the same serious problem: The screw part at the T-handle is smaller than the rest. So that the Thrust Plate does not handle the clamping pressure but transfer this to the black hollow pin! Additionally, the black hollow pin handles the turning strength as well!
@genethompson2064
3 жыл бұрын
Did you have a failure with this vice? The vice is still working great for me, I actually use it more than I would have thought. All mechanical devices have a weakest point, I see no reason the pin wouldn't be a good place to have it.
@moserbua
5 жыл бұрын
Hi Gene, this helped a lot because i had no installation instruction and i had no idea about the 2 sliding pieces which you mentioned were tricky to install them centered. Kind regards from Austria, Hannes
@realprimegaming3925
3 жыл бұрын
Great review btw. What is the reason for the center threaded rod to be off center?
@jccapwell
4 жыл бұрын
Thank you. About to mount mine.
@fredstaff4160
3 жыл бұрын
Gene just put a cotter pin in the one slide and you will not be able to over extend the vise.
@marcelo403polo2
5 жыл бұрын
Did you just chisel out for those support collets??? Good job BTW. Thanks for sharing
@genethompson2064
5 жыл бұрын
Yes, but getting them just right was a bit fiddly. Do this last, make sure the clearance holes are not binding, then put the guides on and mark the relief.
@marcelo403polo2
5 жыл бұрын
@@genethompson2064 Thanks
@Smokestack_Lightning
4 жыл бұрын
Did your vice unscrew completely without any resistance? Mine seems to be hanging up at the end of travel and I cannot separate the mounting plate from the face plate.
@martinallaire9488
5 ай бұрын
Remove the hairpin from one of the slider. Its meant to be a stop.
@treasurerbcsocaaa1639
3 жыл бұрын
How big are the cheeks on your vice?
@genethompson2064
3 жыл бұрын
21" x 5"
@jasondonahue4747
5 жыл бұрын
Thank you for the video. Yost vise are great, but their instructions are not. A+
Пікірлер: 20