Oh Right! Go ahead and trash Dans knots, while your way over in Florida! Go to Wyoming and talk your Smack! Hahahahahahaha You guys are the best!!
@briancrossley1710
Жыл бұрын
You mentioned a couple of times early in the video that the termination knot is for high tensile wire. I don't use HT but still use the same termination knot. Is that still ok or is there a better knot for mild steel wire?
@underduress5761
10 күн бұрын
3:15 You got those videos to show up here!,😂😂😂 I had no real knowledge of fencing until KZitem recommended that other video I watched. This high tensile strength wire seems like a must have for anyone putting up a fence that would be subject to impacts. Good to know. I'll sub from my other channel to boost the algos and keep your channel in my subscriptions for reference. Thanks!
@trackmader
2 жыл бұрын
(Sarcasm font) you forgot to double wrap (end Sarcasm) Nice knot. After a while the knots get much easier and a plain wrap is wrong.
@allanpennington
8 ай бұрын
Im using 2mm high tensile wire for my espalier tiers and the run is 13m long. Im using a ratchet cog strainer at one end to enable tightening. The wire runs through 6 equally spaced L Brackets for support between my fruit trees. What is the best way to terminate this type of wire at the start where I have used a galvanised L bracket with a hole in it, not a post; and then around the shaft of the ratchet. I find it very hard to twist. And I wish I had one of those horizontal spinning feed mechs......I made a hell of a mess when I tried to feed out the first 13m of wire! It only took me an hour to untangle.
@newenglandman2413
Жыл бұрын
No Santa for you this year, knotty boy!
@SWiFence
Жыл бұрын
It won't be the first time. 😆
@Darth_Raider_
2 жыл бұрын
Nice vid. Iv never did that type of fence before. To bad u can't do this with 7 gage tension wire.
@justinpihama3405
Жыл бұрын
Termination knots at your end assembles ( strainers and diagonal stays )
@onetruesoldiervt3686
2 жыл бұрын
Hi found your channel I have 100 diff subs but glad to find you otherwise good!!! I had a question and would appreciate if you could get back it’s about fence posts I was wondering if you could help me locate the ones that you can slide wood down the inside of the posts from both sides horizontally so that’s all and was looking for the ones that aren’t big just snug enough to slide an inch thick the length doesn’t matter obviously but yeah that pattern where both sides of the pole has a insert where the end is covered but like I said you can slide the wood down the sides of the poles from either side thanks
@JonsRanchFencing
Жыл бұрын
Nice video
@ghostedyoutuber263
9 ай бұрын
Prolly doing it wrong... but actually ... prolly not.
@rockroosterfootwearmarketi5378
2 жыл бұрын
Hi, this is Rock Rooster Footwear. We sent you an email just now. Looking forward to your reply. Thank you!
@SWiFence
2 жыл бұрын
Hey there! We're on the lookout but haven't seen anything yet. 👍🏻 Maybe try sales@swifence.com
Пікірлер: 16