Thank you very much for the detailed video. Was worried about tackling this on myself- picking up the tools and going to hit this project next weekend
@HardEarnedBacon
5 ай бұрын
You got it!
@danhambrick6331
Жыл бұрын
Nice job.I bought this kit for my 8.8 that I am building for my Jeep Cherokee.I was just going to buy the axle shafts but decided to go with this kit instead.I have a Eaton TrueTrac and 4.56 gears that I am installing also.
@HardEarnedBacon
Жыл бұрын
Thanks, I'd like to build another XJ at some point and would do TrueTracs again too
@danhambrick6331
Жыл бұрын
I have the TrueTrac in the rear and A Yukon Grizzly locker in the front....
@maxrogers762
Жыл бұрын
Good to see ya back! I'm in the middle of an 8.8 swap so I appreciate ur content. Congratulations on yalls baby! We jus had our son 2 months ago, so I'm right there with ya
@HardEarnedBacon
Жыл бұрын
Thanks congrats to you too!
@cerberus45
11 ай бұрын
extremely helpful video, I'm doing the same thing - the visible machined surface on the end of the shaft after pressing on the bearings would've thrown me for a loop. Thanks for sharing!
@HardEarnedBacon
11 ай бұрын
No prob!
@rl1106
Жыл бұрын
Great video! I'm in the middle of a 8.8 swap as well. I would like to do this mod in the future, but for now its going to be 8.8 posi 4.10.
@HardEarnedBacon
Жыл бұрын
Thanks! Trying to find the time to finish my regear, about halfway done.
@jk_wrangler13
Жыл бұрын
Lots of har work, but it will be worth it in the long run. Congrats on the upcoming baby
@HardEarnedBacon
Жыл бұрын
Thank you!
@jk_wrangler13
Жыл бұрын
@@HardEarnedBacon you're welcome
@waterboy9036
Жыл бұрын
Great tutorial, thank you! Does the shaft require a slide hammer to remove it if you need to do some carrier work?
@HardEarnedBacon
Жыл бұрын
Thanks! I pulled them out after this video was done and I did not need to use the slide hammer. But they may be a little more "sticky" to remove once they are installed with the RTV.
@barrykennedy8760
Жыл бұрын
Might be able to fix my 8.8 now
@HardEarnedBacon
Жыл бұрын
Whats wrong with it?
@barrykennedy8760
Жыл бұрын
@@HardEarnedBacon blew an axel bearing and damaged the housing
@HardEarnedBacon
Жыл бұрын
@@barrykennedy8760 Dang! Yeah this could be a good option for you.
@cerberus45
11 ай бұрын
Its almost been half a year since upload, any leaks?
Пікірлер: 23