www.martinthevlogger.com/canam-motorcycels-info/categories/installation-and-how-to-guides < - More How to and Installation videos here
@andypaterson157
2 жыл бұрын
Hi Martin, Cable / Zip Ties I'm not sure if this would help with the drilling problem (90 Degree Right Angle Drill Chuck Attachment Adapter e Bay) might just give you a bit more flexibility, as for getting the bottom nut into place you could try taping it to a Flat headed screwdriver and place it below the hole, or tape to an open ended spanner and place underneath that maybe would work if you can turn the top of the bolt easy enough. If you are drilling a very small hole could you just do it from the bottom through both pieces and put a rubber grommet in the lower hole as it would never be seen anyway ?? Make life a lot easier. Cheers Andy, P.S Thanks Again for getting my order together.
@MartinTheVlogger
2 жыл бұрын
Good points Andy. Usually i am kind of a guy that can find the otger way round, as this is what my father showed me. But when i am recording i am tired usually thinking how to position what and not to destroy my items just for a video. But thank you, very good poinst you have said. 🤘🤘🤘🤘
@kangurosalvadoreno5527
2 жыл бұрын
Hi Martin, Their are call zip ties, the bloody Mary is looking mad, congrats.
@MartinTheVlogger
2 жыл бұрын
Thank you Sir 🤘🤘🤘🤘
@Waldo1122
2 жыл бұрын
Did you install the heated grips on your Spyder yourself? And if so do you possibly know the dimensions of them? I'm looking to put heated grips on my Spyder, but Can-Am is taking too long to restock them and third party heated grips looks like they're better anyway while costing 50% less.
@MartinTheVlogger
2 жыл бұрын
Hi Waldo, nope. I have my heated grips on TheBeast since 2015 and back then i have asked guys from BRP to put it there for me. However i am not a super big fan of them. Tgey should have at least one or two more options to add extra heat. These OEM are just weak 🤷♂️🤷♂️🤷♂️
@andypaterson157
2 жыл бұрын
Hi Waldo I had heated grips fitted when I bought my F3S (1 setting), and to be honest I'm not to impressed with them, and as Martin said expensive, I have had Oxford grips on a couple of bikes and they were far better and you had far more control over them, hope this helps, Andy
@Waldo1122
2 жыл бұрын
@@andypaterson157 Thank you, I want to get the oxford grips, but I'm not sure if they'll fit the Can Am Spyder grips.
@MartinTheVlogger
2 жыл бұрын
@@andypaterson157 i will also look at those Andy. Thank you. Coz i may need them for rYkers 🤘🤘🤘
@andypaterson157
2 жыл бұрын
@@Waldo1122 you would need to check with Oxford Products, as I think handle bars are 28 mm on the Can Am. Good luck Andy
Пікірлер: 11