Nice video. Thanks for this. Its a pitty the technician could not explain like this on site.
@sujitmishra8249
5 ай бұрын
Thankyou Sir.
@prabad75
6 ай бұрын
Thanks for the programming details for AS3. Can you please provide similar information for AutoSand also?
@sujitmishra8249
6 ай бұрын
Autosand doesn't have so much of complexity, you just have to set the program to A-02 for instant backwash process, then set required volume of water at which you want to set for backwash. That's all you have to do.
@nitapatel6301
Жыл бұрын
Very Nice Thank You For These Settings
@ankit6260
6 ай бұрын
60 litre Brink Tank and 50 Litre Rasin k liye kitna minute Brine and slow rinse rakhen??
@sujitmishra8249
6 ай бұрын
We have our standard settings based on softener model. Please do not feed your customised datas.
@krishnasam6198
4 ай бұрын
Why it should recharge? What is the purpose of recharge? Also we have installed the same softener. Service person kept the days for 3 days and he asked to add salt for evry three days. But since we are not using the softener frequently,Im adding salt after 7 days.. Is tat an issue?
@sujitmishra8249
4 ай бұрын
The purpose of recharging softener is because after a period of time, the resin beads get coated with hard minerals and need to be cleaned which is done by including multiple recharge process including brine injection process. If you are not frequently using the softener then I recommend you to use volume based recharge process where softener will go into recharge process only when required volume has been utilised by you.
@prashantgupta1966
4 ай бұрын
Hello sir can you share the model dependent settings for as8? Is it the same as AS6?
@sujitmishra8249
4 ай бұрын
More or less it is similar to it but please reach out to our local service provider for precise settings since there is a difference in timings & resin qty.
@prashantgupta1966
4 ай бұрын
@@sujitmishra8249 sir my as8 model has A-04 SETTING too besides A-01 to 03. I think company person has mistakenly kept it as A-03.can you confirm if AS8 has has A-04 setting
@sujitmishra8249
4 ай бұрын
@@prashantgupta1966 We have settings between A-01 to A-04 where A-02 & 04 is used on specific field requirements only. A-03 can be used for AS8 as well.
@choudharymanishtarar265
Жыл бұрын
Sir multimeter lena h kya sath😜
@dibsah1
Жыл бұрын
What is the E3 error means ??
@pankajmenaria8848
2 жыл бұрын
Where can i get circut diagram of its main pcb
@nitapatel6301
Жыл бұрын
👍👍
@filter5823
2 жыл бұрын
Sar Answer plij
@jaipalsurana5308
2 жыл бұрын
Ye product sahi nahi hai...koi sarvice nahi hai after sales. So not purchase it
@sujitmishra8249
2 жыл бұрын
Sorry for the inconvenience caused. Kindly lodge your complaint on 022 68486848/022 27881234. If already have complaint no then write at zerob@ionexchange.co.in
Пікірлер: 26