Yes, there certainly is lots of good products out there to improve most RV’s, glad you enjoyed our Vid and thanks for your comments.
@richardcharlton8259
4 ай бұрын
Thanks for the tip on the seats ours are short as well time for new ones
@grahambelby9117
4 ай бұрын
Yes, they certainly needed improvement.
@bradcarey7617
4 ай бұрын
Awesome as usual thanks Graham. We installed the same lock box upside down as i think the dust cover could vibrate loose and hang down on the corro. ZPP72
@grahambelby9117
4 ай бұрын
That’s a good point, didn’t think about that. Glad you’re enjoying our vids. Cheers Graham
@michaeldallimore8590
4 ай бұрын
Great tips thanks.
@grahambelby9117
4 ай бұрын
Your welcome, thanks
@DoogsBrown
4 ай бұрын
Love your tips n tricks thank you
@grahambelby9117
4 ай бұрын
That’s great, we like sharing.
@user-BryNic333
4 ай бұрын
Nice work guys
@grahambelby9117
4 ай бұрын
Thanks, glad you enjoyed it.
@stephenboag9830
Ай бұрын
I like your improvements Graham, thank you for sharing. I've fitted a Blackjack to our 18.6 BASE. I have the wiring loom and switch that you've used in this video and plan to wire it like yours. Where did you connect the negative wire in your loom? Also, I'm planning on adding an Anderson plug under the area of the tunnel boot to power our 45 litre fridge when camped up. I put the fridge under the van. Any ideas where to pick up a power lead from the BASE?
@grahambelby9117
Ай бұрын
Hi Stephen, good to hear from you, I’m presuming you have the same Enerdrive Power Board system as mine. On the video where I added the additional fuse under the seat, you will find the neutral bar next to the existing fuses, plenty of spare terminals to connect too..just unclip the clear plastic cover by squeezing the ends in to access the Silver bar. For your additional Anderson Plug for the fridge, you could add another circuit where I have added the Black Jack circuit in the same way and run a “8 B&S “ cable through the chassis channel with the Black Jack circuit, fit a separate 30amp fuse for cable protection. Don’t forget to make good tight connections and label everything for future reference. Hope that helps, any more questions, just send me another message. Cheers Graham
@stephenboag9830
Ай бұрын
@@grahambelby9117 Yes Graham, the same Enerdrive power Board system. Thanks heaps for the help. Very much appreciated. Looking forward to your next videos. Take care. Cheers Steve.
Пікірлер: 19