Zoning done correctly works fine. Like anything else that is incorrectly installed will fail.
@TurpInTexas
3 ай бұрын
Absolutely true! I converted my system from 2 air conditioner system (one upstairs, one downstairs which worked like crap by the way), to a single air conditioning system with 7 zones, getting rid of one of the air conditioners all together and it works beautifully, keeping the house within half a degree because the system puts the heat or cool where it needs to be depending on the season.
@tonybochiano
3 ай бұрын
You are the best
@phoenixhvac-r828
4 ай бұрын
Agree with your opinion on zone systems, especially when developers use them in an attempt to use lower cost undersized equipment.
@bobbydisano7293
4 ай бұрын
I agree with you to an extent if zoning is done properly equipment life shouldn’t diminish but again everybody nowadays look at their wallets and get chuck in a truck to put their systems in😂
@TurpInTexas
3 ай бұрын
I did all the work myself, got rid of all the flex ductwork, went back with suspended metal pipe then sealed and wrapped with insulation, with full modulated dampers to the 7 zones, each sized for the volume of each area as needed. Bought all Trane thermostats and zoning panels used and saved a ton of money. The real pain was installing additional joists in the ceiling and flooring the attic, installing lights, etc, before I started the zoning project, but had a lot of fun learning lots of cool stuff about Trane systems. Its easy to see why Trane is the best!
@austinbell5792
4 ай бұрын
Most of the Zone systems I see in my area are ALL new construction cookie cutter homes.
@user-ln7of9gs4s
4 ай бұрын
If you wanted zoning use mini splits.
@realSamAndrew
4 ай бұрын
I would make lemonade out of sour lemons. Disconnect the bypass duct from the coil end and dump it to the attic space instead. Now you've got a cooled attic!
@myHVAClife
4 ай бұрын
It’s a basement
@briancarlisi2224
4 ай бұрын
It would have been interesting to see your SH after you disconnected the bypass (after the damper). Maybe you did and did not film. Thanks for sharing!
@myHVAClife
4 ай бұрын
Bypass was not closing all the way dumping 50deg air into the coil. SH did not come up. I’ll try to go back when replace the bypass.
@briancarlisi2224
4 ай бұрын
I meant disconnecting the bypass duct, not the damper itself. Sorry for not being clearer.
Пікірлер: 15