A DIY channel that shows various projects the owner has done on his own, including research and the why of what's being done.
Пікірлер
@bumpyjohnson5181
Күн бұрын
thank you
@stonecyz
9 ай бұрын
Did U use type B 3/4 copper?
@christinebosshamer-pm2jf
Жыл бұрын
Omg I've been putting the arrow on 0 and then lining my mark up with 90 or R
@robbiesehra9450
2 жыл бұрын
Lol, I’m about an inch off
@barmalejwasqoff9317
2 жыл бұрын
Write full name of bender and size of pipe, type too (hard or half-hard)
@theonlyakuma
3 жыл бұрын
poor demo ... u wanted 12 inch and didnt even get it.
@toddweiler9389
3 жыл бұрын
TUBE BENDING SIMPLIFIED For anyone who wants to easily and precisely learn how to bend any size tube, with any number of bends, of any degree from 1 degree to 180 degrees, onto a 20 -foot stick of tube, watch the 5 free videos at kzitem.info Then order yourself a very inexpensive book which will teach anyone, in less than 2 hours how to become the best tube bender or pipe layout mechanic that they know. Order TUBE BENDING SIMPLIFIED through either Amazon.com or through E-bay.com Your book will arrive at any address, anywhere in the 50 United States less than 1 week after you order it. TUBE BENDING SIMPLIFIED
@heitorofficial
3 жыл бұрын
Eu tenho um tô vendendo
@UnionParkPlumbing
3 жыл бұрын
Very good video! Easy and clear explanation
@ismaelcardenas5507
3 жыл бұрын
Bc you put it on the r not on the 90 if you measure the marking on the bender that how much u were off
Пікірлер