Can’t you just use the drain plug to drain it? And is there a fill plug on top to refill without taking the bottom cover off? Thanks.
@Floridamanfresh111
Жыл бұрын
How did you get the drain pan off after removing the bolts?
@Tyler-sk2rm
Жыл бұрын
Mine is leaking. Think it’s the seal?
@valhallaaerial8152
Жыл бұрын
Most likely, thats 90% of leaks. I’d pull it off and take a look at the cover and housing as well to make sure there are no cracks or any damage
@mrmudjm
Жыл бұрын
I think you're shortchanging yourself on some performance.. I believe the factory uses 30w in the diff.. I've seen suggestions to use a synthetic 5w30
@CaribbeanSimPilot
Жыл бұрын
Would that Royal Purple 5w30 be good?
@jackbarrier7267
10 ай бұрын
My 2013 TXT calls for 30W motor oil to the fill plug level.
@eprater82
Жыл бұрын
Should never spray up into the diff with any type of degreaser. There will be residue left over that will degrade the new fluid. Wipe out what you can and leave it be.
@Detillion81
2 жыл бұрын
Nice step-by-step. Clear and concise. Thank you.
@fredgreen6631
2 жыл бұрын
Incomplete description show cap being reinstalled etc and pulling plug would be better.
@SonicOrbStudios
2 жыл бұрын
Waaay too heavy on the gasket maker. Less is more when it comes to the stuff
@bradaguilar49
2 жыл бұрын
Very helpful thanks!
@frankcastle5294
2 жыл бұрын
No idea why you would add slip diff friction modifier to a golf cart differential. That stuff is expensive and serves absolutely no valid purpose in a cart diff.
@stevendaniel8704
Жыл бұрын
i believe they are limited slip with friction material
@frankcastle5294
Жыл бұрын
@@stevendaniel8704 I've worked on over 200 gas and electric and have yet to see a limited slip. They are all Dana 40's and open.
@Jason-wx7ms
2 жыл бұрын
Just wondering if there is concern of the gasket maker seeping on the inside of the differential? You would think that if it oozed out the outside that it would ooze on the inside too.
@valhallaaerial8152
2 жыл бұрын
It will, but if you wait the amount of time required it will set and be fine
@masondawson4061
2 жыл бұрын
How did the pump end up working?
@valhallaaerial8152
2 жыл бұрын
Work fine once you get it going
@ShaneHubber85
2 жыл бұрын
Are these motors just noisy? I have a 22 S4 72v and I swear the motor makes a lot of noise. For sure when I left off the throttle.
@valhallaaerial8152
2 жыл бұрын
Its an electric motor, its normal to hear that electric 'whine' when your on the throttle, when you let off you hear everything the motor sound obscures. It could be as simple as the sound of the tires rolling on pavement, could be axle bearings, or it could be the gears in the diff, very hard to tell without hearing it first hand
@retiredinthailand24
2 жыл бұрын
I see that after you tightened it back up you seem to have smeared more gaskets sealer around the edge...did u add more because it leaked or were you just smearing the excess?
@valhallaaerial8152
2 жыл бұрын
Just ran my finger around the bead, I should have just let it be...
@BrandonBigB956
2 жыл бұрын
Leave the excess and let it dry then run a razor around it and you have a nice clean original gasket look.
@Mopar-yd3ly
3 жыл бұрын
Once u fill it to the point that it starts to drip back out of the fill hole, you're done. If you then add more thru the vent you have overfilled.
@david65711
Жыл бұрын
On a normal auto application that's true but I have to wonder about the hub bearings if the fill hole is below the axel tubes you might need some more
@jasonkreber1942
5 ай бұрын
Not true when I dumped my pan it was filled way fuller than that
@tarhesabz
3 жыл бұрын
Interesting design, very unique. Thanks for sharing.
@usmcraid5332
3 жыл бұрын
What an ugly gasket jeez…
@valhallaaerial8152
3 жыл бұрын
Can't argue that! I should have added...don't smear it with your finger like I did
@wooddawg4868
3 жыл бұрын
Why didn’t you just drain from drain hole? Or you could have drained from fill hole.
@valhallaaerial8152
3 жыл бұрын
I did end up pulling the drain plug and drained what I could before dropping the pan
@David25522
3 жыл бұрын
Great tutorial video! Thank you!!!
@valhallaaerial8152
3 жыл бұрын
Thank you, glad it was helpful!
@brianpinkins1410
3 жыл бұрын
What year is this rxv?
@valhallaaerial8152
3 жыл бұрын
2013
@utubeisgood1669
3 жыл бұрын
Try to film less zoomed I feel like it’s hard to see
@valhallaaerial8152
3 жыл бұрын
Used my phone, I should have used my sony camera where I had more control of the zoom. I'll start using that from now on. Thanks for letting me know!
@winfieldsam5404
3 жыл бұрын
Can you post a like to the bench seat/sofabed. Thank you.
Пікірлер