Thanks for the video. Very helpful and made it easy!
@pauloneill8912
Жыл бұрын
are there drain holes in door bottom?
@mikeobrien5867
2 жыл бұрын
Good video. The clicking on the original switch pin is not a sign of failure. Both the original clutch switch and the brake switch have a ratcheting pin. Gently pull the pin so its fully extended when you install it and it will set itself to the appropriate length. Sometimes resetting the pin is enough to get the switch working again.
@jordanjean-jacques3179
2 жыл бұрын
By far the simplest, most direct instructions. Thank you brother.
@dennisleliveld4200
2 жыл бұрын
Thx man!
@t-dub74
Жыл бұрын
@dennisleliveld4200 , I just changed mine , it was so quick and easy! Thank you so much for posting this video !
@lesvosace602
2 жыл бұрын
I cant get my new switch to click into place whatever i do. Its close but it just wont go back in
@dennisleliveld4200
2 жыл бұрын
I also had that problem it doesnt go back as easy as the removal part but it should work. Try removing the air duct so you can Apply more presssure. My brake sensor housing was different from the original one but it still worked. Also buy the cheap version. The hella one Oem part broke 5 months after installing. Now i bought the cheapest one like 7 euro's and it works for over a year now!
@sopheandseth
3 жыл бұрын
Thank you so much! That was very helpful!
@russellmills2044
3 жыл бұрын
Thanks for the video it was very helpful It's a bit awkward to do as the space is very limited. A tip for twisting it off. Unscrew the Aircon /heating duct.This is just one short screw This allows you to get your whole hand around the switch and makes the twisting much easier
@Eomak
3 жыл бұрын
thanks...some guy told me while driving that my brake lights are flashing on and off when braking..they only came on when lightly pressing pedal and not on hard braking..going to do on weekend.
@dennisleliveld4200
3 жыл бұрын
Good luck with that! Sounds like the same problem i had when it started to fail! I removed it and cleaned it and it was completely dead.🤣
@t-dub74
Жыл бұрын
I am happy I found your video, I am having the exact same issue, I am going to order a new one .
@babybrazaa
3 жыл бұрын
I removed it easly but i cant lock it back into place... :(
@dennisleliveld4200
3 жыл бұрын
Try turning it counterclockwise make sure you keep light pressure on the switch so the small clips will lock in the switch mounting bracket. Make sure u know how it looks so take a light so you can see what you are doing it is a little tough to get to
@MrGreencheetah
3 жыл бұрын
Great video -- just getting ready to do the job . . . love your accent!!!
@dennisleliveld4200
3 жыл бұрын
Thanks for that! 👍
@williamgoodwin7618
4 жыл бұрын
How do you mark the window with tape if the window is NOT moving because the regulator needs replacing?
@dennisleliveld4200
4 жыл бұрын
Than you just try to mark the position of the window holding clamps via a marker or by mesuring the distance between clamp and glass. If offcourse it is accessible . Otherwise loosen the whole system with window still in it and wiggle it towards the right spots to loosen the 2 window holding clamps
Пікірлер