Hi there, I'm sorry no we don't supply to the US unfortunately.
@jamesnolan7598
2 жыл бұрын
Very useful video thanks. We found it very important to ensure your partner is holding the shed parts tight when screws are going in, as they can slip otherwise.
@racingrooster4642
2 жыл бұрын
Just purchased one of these ,Does it have to be on bearers or can I put straight onto slabbed area ?. You made it look easy ,we shall see next week .lol
@albanyshedco
2 жыл бұрын
If you have a level slabbed area then the shed could usually go straight onto that without bearers. Check with a spirit level if you aren't sure. There are floor joists underneath the floor that keep it slightly raised off the ground so raising it up further on bearers would be optional (may be useful if the area gets wet or is not quite level).
@williamcampbell2800
3 жыл бұрын
Are the nails and screws provided with the shed
@albanyshedco
3 жыл бұрын
Hi William, Yes nail and screw pack is provided with the shed, along with felt, trims and glass if applicable. You would normally just need a few tools, a helping hand and a nice level base.
@nafs53
3 жыл бұрын
I'm about to embark on a second shed build like the one shown here. Useful tip. When using a cordless drill, use the correct clutch settings so that you don't bury the screw too deep in the wood frame like I did years ago. Use a lowish number to make the screwhead ( + ) flush with the wood surface. If you have to disassemble the shed later, deep buried screws are a pain to remove..👍
@doncarlos6314
4 жыл бұрын
Great instructional video! Thanks
@omarismith3655
4 жыл бұрын
No info at all about how to drill, if needs pre drilling Just two clowns putting up 4 sides to a shed. Useless Video
@sleepypanda6790
4 жыл бұрын
How to drill: 1. Pick up drill 2. Aim pointy end at wood 3. Pull trigger Best of luck Roy, I think you're going to need it.
@NobbyN
3 жыл бұрын
Just a thought mate but maybe look up diy for complete beginers. There's some great vids and tips on here on how and when to Pre drill holes. How and when to use nails or screws. How to use a hanmer and a screwdriver etc etc. I'm pretty useless to be honest but found this helpful. Have a good day 👍 Thanks for the share guys 👍
@mister.c4631
3 жыл бұрын
I recommend pre drilling holes and then use screws on the inside panels as nails over time loosen, rust & adverse windy weather stresses them easier than screws. Takes longer but better shed in long run imo
Пікірлер