I don’t know if you drive the car on the limit, but could you feel different any improvement regarding to aero dynamics?
@kinlongfong5847
3 ай бұрын
thanks, thats help a lot
@LuzianPP
4 ай бұрын
Just the video I was looking for thanks
@DarrelLaBossiere
4 ай бұрын
Sweet. Mine is being shipped rn but it's better because it also adds 25 lbs of torque.
@Sxdisfy
4 ай бұрын
I’m guessing you dislike the two tone color of carbon fiber cause I do to I prefer gloss black accessories on my car haha
@WadeWilson-
4 ай бұрын
Do they have these for quad exhausts?
@chrisayres7974
4 ай бұрын
Threadlock lads
@nimaO_G
Жыл бұрын
Isn’t it the b48 not n20?
@aqzi1027
Жыл бұрын
N20
@PoojaSharma-lj2pg
Жыл бұрын
Nice car you got
@savige2012
Жыл бұрын
I need to know. Did you crash your car? Did you start smoking ice and sell your car? Why no more uploads man?
@Jason.cbr1000rr
Жыл бұрын
Hahaha asked like a true Aussie aged 20-28... and from southeast Melbourne.. 😂
@savige2012
Жыл бұрын
I fucking love you bro, thankyou so much for this video, liked and subbed <3
@GamersLabNow
Жыл бұрын
HELP !!! Any idea how can i remove this lip after removing the screws? This 3M tape is so good that i can’t move the lip ? Please help!!!
@DSBsky77
Жыл бұрын
I would use nuts and bolts with washers. The front of the car takes tons of impact from the air. Screws will strip out IMO.
@lukswi134
Жыл бұрын
Thanks for that. It also helps when you replace/ remove BMW 4series G26 diffuser. Actually no need to unscrew the screws just one by one pop the clips. It was more complicated with the first clip on the right side and the first on the left but then it's very easy
@sara.minaaa
2 жыл бұрын
I have the same car in the same colour and I freaking love it ♥️ best car in the world 🔥🔥🔥
@christhis1986
2 жыл бұрын
Where did you get your rear bumper reflectors that light up?
@nickmartin560
2 жыл бұрын
I fitted the exact same one but used the enclosed screws and speed fasteners. Mine ripped the screws out the centre when I went a little quick then it dug in and shattered. Plastic too hard in my opinion. Hope I have more joy with number 2. Will use bolts and washers for the centre this time round.
@fabricecadet9109
2 жыл бұрын
That end haha 😂
@savige2012
Жыл бұрын
Bruhhh im sitting here crying hahahaha
@grizzle273463
2 жыл бұрын
That looks slick
@63mesiken
2 жыл бұрын
Looks good. Where did you order from?
@hrithikkmr
2 жыл бұрын
Link in description. However, it didn't last very long haha
@macmad6959
2 жыл бұрын
Great video bud, looks awesome.... Did this on my F33 a few years back.
@corazon9365
2 жыл бұрын
So if you dont have „M“, you cant get any Diffusor?
@hrithikkmr
2 жыл бұрын
Unfortunately yes. These diffusers are only compatible with M Sport Rear Bumpers.
@corazon9365
2 жыл бұрын
@@hrithikkmr is there any opportunity to get a diffuser for my 430i bmw? It looks so boring without one Thank you
@hrithikkmr
2 жыл бұрын
@@corazon9365 Most of the diffusers are only compatible with the M Sport Rear Bumpers so until you get on of them, the diffuser won’t fit non M-Sport bumpers.
@potatopotato5631
3 жыл бұрын
How did you get Different Colour Logos? where can i buy some
@hrithikkmr
3 жыл бұрын
I do regret going for the green ones (no idea what I was thinking) but they are stickers I purchased online from Superwrappz UK. Link: www.superwrappz.co.uk/
@yanny4784
3 жыл бұрын
Does that work on a 2014 428i?
@hrithikkmr
3 жыл бұрын
Yeah mate. Most of these diffusers, regardless of where you get them from should work on 428i given it has the M Sport Package with the M Sport Rear Bumper. Won't work if the rear bumper is NOT M Sport.
@flywithusMSFS
3 жыл бұрын
The way it got screwed up is that he used wood screws for the middle part, beginner mistake.
@georgiancalin8613
3 жыл бұрын
Did you actually managed to install it without removing the rear bumper? I bought two from Ebay which didn’t fit and the sellers told me I should remove the bumper. I watched your video and explain to them it shouldn’t be removed in order for the diffuser to be installed but they were adamant that it needs to be removed. 😏
@hrithikkmr
3 жыл бұрын
It was a bit of a mission and i did manage to get it on. I guess it may have been easier had the bumper been removed.
@allanzayden2200
3 жыл бұрын
Instablaster.
@reginaldwashington6368
3 жыл бұрын
So the same damage happened to my lip. Comes from improper mounting. The two screws in center are self tapping. They eventually lose grip and the lip sags and rips. My lip damage looked just like his. I was on the highway, I could tell when it came loose. I know I didn’t hit anything, when I looked it there was a chunk missing from the lip. After research I found that a piece that should come with these kits, a installation plate was not included. It keeps the two screws in the middle support. The screws won’t lose support like they did from being screwed into plastic.
@hrithikkmr
3 жыл бұрын
This is very helpful for my next lip! Thanks.
@rifle
3 жыл бұрын
Do you know the name of this piece? My screws keep coming loose and I'm about to buy a new one but don't want the same thing to happen again. Thanks!
@f82f82
3 жыл бұрын
@@rifle Same here, any updates?
@marcuslind9154
2 жыл бұрын
@@f82f82 Just cut out some small metal plates and put in Into the small small rectangular hole under the front just where the 2 screws go. For the original BMW m performance front there is a metal plate included but for some reason not for pirate copies..i found out the hard way too
@jay-wm3lx
3 жыл бұрын
U should do a lci tail light swap
@hrithikkmr
3 жыл бұрын
I would but honestly, I prefer the pre LCI taillights... Maybe some aftermarket lights in the future though!
@fondoo
3 жыл бұрын
#1 reason why I wont put one on. After seeing #kiesmotorsport getting his completely chewed up
@lq5280
3 жыл бұрын
hey bro great vid. I got the same diffuser as you and installed it but I found at the ends it doesn't match up properly. I mean there's a bit of a gap. Did you have this problem and if so how did u fix it
@hrithikkmr
3 жыл бұрын
I did have this problem but there was not much of a gap so i just got someone to help me out to hold it in place and then secured it on.
@CallumColes
3 жыл бұрын
Great video! Shame about the ending... How did you smash it up!?
@hrithikkmr
3 жыл бұрын
the bolts in the middle came loose so that middle section was sitting lower than the rest of the lip and then i must have hit something on the highway and it just ended up like that unfortunately.
@yankiyuksel
3 жыл бұрын
What size bolts did you buy?
@hrithikkmr
3 жыл бұрын
M5 to attach side parts to the bottom lip and then I used the bolts that were already under the car and the ones that came with the lip to attach the it to the bumper.
@reginaldwashington6368
3 жыл бұрын
What did you mount the last piece to? The center raised piece in the middle of the lip?
@hrithikkmr
3 жыл бұрын
Drilled a hole into the bottom of the bumper and secured it on with a couple screws
@josephhunter857
3 жыл бұрын
How much was it?
@hrithikkmr
3 жыл бұрын
I bought this one for $300 AUD.
@snois2
3 жыл бұрын
How would it look like if you just had the bottom part installed so that the other part is original with the color of the car? Would it look weird?
@hrithikkmr
3 жыл бұрын
Not too sure man but i don’t think the bottom part of this specific type of lip will fit without the two side pieces. You can get other lips that are basically only the bottom part and they also look pretty good!
@AM-lj3yg
3 жыл бұрын
Good video bro, I’m gona give it a try today, mines a black 2018 f36 got a carbon fibre diffuser hope it looks as good as the photos I’ve seen.
@hrithikkmr
3 жыл бұрын
i’m sure it will!
@saintpaddy2118
3 жыл бұрын
loving the content so far bro! i recently bought a 428i and so these tutorials are perfect. keep it up!
@hrithikkmr
3 жыл бұрын
Thanks man, appreciate it! 🙏🏽
@PoojaSharma-lj2pg
Жыл бұрын
It's luve car
@deanodiddy
3 жыл бұрын
My gf comes out and watches me do work on my car be she won’t admit she finds it sexy. Bitch I see you looking.
@hrithikkmr
3 жыл бұрын
BRUH... that’s my sister 😢
@deanodiddy
3 жыл бұрын
Haha sorry bro
@Vincentcapocelli
3 жыл бұрын
are you sure that's stock? i have the same car and it never sounds like that
@hrithikkmr
3 жыл бұрын
this vid was recorded when it was stock yes. let the car get warm, put it into sport + and rev around 3-4000 RPM.
@rusugaby7878
Жыл бұрын
i have the same car just try to rev it in sport+ it opens the flap
@DarkenedRez
Жыл бұрын
I’ve never had a burble on my stock 428i tho even in sport +
@aqzi1027
Жыл бұрын
hmm that’s odd you should
@Jason.cbr1000rr
Жыл бұрын
@@aqzi1027same thats bullshyt all I get is small quite burbles on coming to a stop or home street.. just a tiny bop bop bop that you can feel moreso than here imo
@jamesjones2767
3 жыл бұрын
Love your content and sick f32! How did you get your diffuser to fit properly? Did you have some issues?
@hrithikkmr
3 жыл бұрын
Thanks James! The fitting was not 100% but i got someone to give me a hand and eventually after playing around with it for a while, we got it to fit. I’m still driving around today and it’s been quite sturdy and no issues.
@jamesjones2767
3 жыл бұрын
@@hrithikkmr thanks dude 👍🏻 lol I’ve just spent the last 2 hours in the rain putting one side on only for the other side to pop out! 😡 I’ll keep trying!
@jamesn4901
3 жыл бұрын
@@jamesjones2767 did u get it to work bro? I did mine but one end keeps popping out. I contacted the guys mjmods and they told me to use glue. I’m like wtf
@itsjustash1094
3 жыл бұрын
I'm about to get a diffuser for my f36 but I can't decide between the colours. My f36 is in imperial blue but it looks black during the day. I don't know if gloss black would suit or if I should just get the grey looking one.
@hrithikkmr
3 жыл бұрын
In my opinion, the gloss black diffuser goes well with any colour car!
@itsjustash1094
3 жыл бұрын
@@hrithikkmr I thought that at first but now I think it suits more if the car is actually black or white. Where as I have a black/blue colour and this glossy black diffuser may outshine the actual body paint. What colour is yours?
@hrithikkmr
3 жыл бұрын
Mine is carbon black so it’s also a black/blue colour and i didn’t it find it to outshine the body paint. Have you considered the carbon fibre piece as an alternative to the gloss black?
@itsjustash1094
3 жыл бұрын
@@hrithikkmr carbon fibre and the matte black are the two style Ive been trying to decide on. Thank for your help, I will be making a decision very soon and upload a video like yours. 🔥
@LongoHighlights
4 жыл бұрын
Whose car is this?
@hrithikkmr
4 жыл бұрын
Julian Minato Idk, just found it parked... Thought i’d change out the parts on it.
Пікірлер