Did you ever get this fixed? I have the same problem in the same mystery.
@halilibrahimsozer5736
3 жыл бұрын
I have same problem too .
@daverusso758
2 жыл бұрын
Same. Have either of you gotten it fixed
@ryancichewicz2321
2 жыл бұрын
@@daverusso758 Wow this is an old thread I didn’t plan on getting a notification for. But yes I did fix it. I did have to replace the spring, and that wasn’t all, The machine is very picky about being perfectly clean in all areas. If you have a BB stuck anywhere or some debris/powder in the first station where it drops down they can wreak havoc. My advice is to tear the lower end of the press apart clean and lubricated very well and reassemble.
@daverusso758
2 жыл бұрын
@@ryancichewicz2321 I will give it a shot. Thanks!
@ryancichewicz2321
2 жыл бұрын
@@daverusso758 Performing the collet cleaning was also key to my success check out this video on how to disassemble clean and lubricate this part: kzitem.info/news/bejne/k5unumF8iZt2i44
@sneakinggodzilla6328
6 жыл бұрын
Mec offers this solution : kzitem.info/news/bejne/xa2AsYeJsmt2pKg It worked for me
@amlee9567
8 жыл бұрын
Had to send the 9000 back to MEC. They replaced many parts, 16 to be exact. Well worth every penny. I would have never gotten this machine to work. In 2 weeks time, it came back and works perfectly. Just have to add the larger primer tray now.
@xxstarforbrianxx
8 жыл бұрын
make sure you also lube every pivot point with a little gear oil and the collet fingers with anti seize compound
@xxstarforbrianxx
8 жыл бұрын
have you tried adjusting the eccentric nut that controls how far the slide bracket travels? it also have the wider end pointing upwards.
Пікірлер