How do I do this ? It looks like you connected it to the negative terminal but how did you connect it to the engine does it come with a clamp on the other side connected to the engine or where can I buy this cable post a link
@nekawallc6324
5 ай бұрын
You figure it out?
@clintho1
Жыл бұрын
disconnect to prove it 🤔
@albertsautodiagnosticsllc2130
10 ай бұрын
There was 12 volts of voltage drop on the ground side and vehicle didn't start before I supplied the ground trust me this was the root cause of my no start 😉 thanks for watching!
@sebastianpiech8465
2 жыл бұрын
I’m trying this when I get home thanks!
@ChochiLuko
2 жыл бұрын
if you can't afford a snap on or fancy oscilloscope, just use a cheap multimeter with a graphical display and transmitter clamp. You'll still get the info you need or if you're starting out and have easy to access cylinders just use a mechanical compression tester. This is a no-mess method though.
@jahrain1693
2 жыл бұрын
Thanks alot
@rosendo35rf
2 жыл бұрын
How do you set up the scope. Lab scope, graphing multimeter or digital multimeter? I have a modis edge.. I would like to learn how to spit from scratch
@tonyruiz2046
2 жыл бұрын
⭐👍⭐
@TC-uu8rh
3 жыл бұрын
Come on your better than that right? Doesn't seem like an emergency so find the actual bad ground and clean it up a bit. Find issue and root cause of issue... Bandaids are temporary
@offroadextraordinaire2423
3 жыл бұрын
Think he did the bypass moreso for troubleshooting the actual problem, pretty sure it was never meant as a permanent fix..
@TC-uu8rh
3 жыл бұрын
@@offroadextraordinaire2423 cool.
@albertsautodiagnosticsllc2130
3 жыл бұрын
@@TC-uu8rh i did find the bad ground that yellow wire is attached to the ignition coil ground wire that had completely corroded off the block this was strictly for trouble shooting to verify that this was my only problem and the vehicle would indeed start I ended up sauldering a new wire and eyelet on and cleaned up a new ground on the frame and bolted it to the frame for the actual repair thank you for watching 🙂
@albertsautodiagnosticsllc2130
3 жыл бұрын
@@offroadextraordinaire2423 yes that is exactly what I was . Just a bypass test to verify problem would indeed be fixed with a new ground
@TC-uu8rh
3 жыл бұрын
@@albertsautodiagnosticsllc2130 thats what im talking about. professional. Im glad thanks for explaining and update on the proper repair. Now I'll go check out more of your content
Пікірлер