Dude where the hell is the on switch on these things. I took the whole damn thing apart and it is no where! Mine doesn't have the button!
@sharontooth3590
2 ай бұрын
I replaced the batteries in mine and now they come on during the days what am I doing wrong 🙈
@diahhamdani5915
2 ай бұрын
🙏🙏🙏❤❤❤❤🇮🇩🇮🇩🇮🇩🇮🇩
@michaelmcgill4520
3 ай бұрын
I bought these last year,and only one was working as of 4-8-2024. Yes the day of the eclipse. I watched your video, and to my delight, it worked very well. Thank you for taking the time to share your fix with us.
@kurushtarapor8134
6 ай бұрын
U are a genius. 😊Thankyou🙏
@Jizzlewobbwtfcus
7 ай бұрын
Two minutes! Zero nonsense! 1000% Brilliant man! 10,000 Thanks! On a side note the ones I have had no external switch or exposed wiring running down the middle so I unscrewed the small screws along the top and opened it up. Turns out that was unnecessary as all you have to do is unscrew the solar panel top piece. DOH! Once opened remove the white bulb-like cover by twisting. Inside there is a long (about 70mm x 5mm) thin circuit board which has about 5 or 6 small LED lights spaced apart. The whole thing is jutting out from under the solar panel housing with a switch labelled _"On / Off"_ . Guess which one I had to switch it to lol. *NOTE:* The circuits are very sensitive so be careful
@junaidfaiz
8 ай бұрын
Great work but there are screws to open it up instead of cutting the plastic shade.
@Jizzlewobbwtfcus
7 ай бұрын
Seems there are quite a few variations on this model.
@only1genious
8 ай бұрын
Thank you very much, I just did it and brought it back to life 🎉
@tonycorona5003
9 ай бұрын
😊 GREAT VIDEO AND STRAIGHT TO THE WORKING DETAIL. I JUST GOT 6 OF THOSE SOLAR FLAMING CANDLES. I AM GLAD I CAME ACROSS YOUR VIDEO. THK YOU SO MUCH FRO DEL RIO TEXAS 😊😊😊 GOD BLESS YOU.
@kameleon1576
11 ай бұрын
Le lien svp
@troyanderson222
Жыл бұрын
Thankyou. Great video!
@paulagraham8464
Жыл бұрын
I did it!! Thanks!!
@marktroyer2754
Жыл бұрын
Thanks just tried I just pulled wire through, it worked
@cbass2755
Жыл бұрын
Thank you!! I just came in from my garden bc one light isn’t working. I checked the switch, and yes, it’s on. But no light. Mine are exactly like yours except their smaller. A gift from my brother. So…I think I’m going to try and do what you did. Wish me luck! Michigan here..May 31, 2023 and the time is 10:56 pm. Good night Sir…
@teddytinsley4121
Жыл бұрын
Which power supply did you use? You turned it off/on.
@TheHighlanderprime
Жыл бұрын
Thanks for the tip. However, wire could have been fished out with a hook without destroying the lower case.
@kareemali2922
Жыл бұрын
i bought a new pump and fuel filter (black assembly) and i hear it spin but nothing spits out, what could be the issue?
@MotoJayy
5 ай бұрын
I had same issue any fix???
@kareemali2922
5 ай бұрын
@MotoJayy the fuel pump wasn't wired properly in my case , i had some wires crossed
@MotoJayy
5 ай бұрын
@@kareemali2922 hmm how did you figure out it was wired improperly?? That might be my issue I can hear it spinning but nothing comes out
@kareemali2922
5 ай бұрын
@MotoJayy I watched a step by step installation videos and realised i switched the negative and positive wires, I too thought it was weird af to hear the pump run but not actually pump
@chrismakin4142
Жыл бұрын
THANK YOU SO MUCH !!
@chrisdickinson2258
Жыл бұрын
How does it charge now
@sylviawalker7993
2 жыл бұрын
I did this bypassed the switch but light stays on any suggestions on why??
@sylviawalker7993
2 жыл бұрын
When I change the batteries on these I turn off the switch change battery,but when I turn it on inside or put my hand over it,it goes on but when in daylight it does not turn off can you help?
@tvbaby3508
3 жыл бұрын
That's what I thought. Isn't it like 6 screws on the casing and then 1 screw just below button on the handle? 7 screws and you do not have to break the casing.
@mati211p
3 жыл бұрын
Yes, and you can especially use solder iron to short two switch pins. The is little problem with changing battery, you need use some heat source - can be hair dryer if you don't have hot air, and melt glue, after changing battery melt glue again and close it. After cool down you can assembly it again.
@mati211p
3 жыл бұрын
Fix is easy, but you destroyed case. That version is easy to unscrew and fix without damaging. That is the most common failure for that lamps, sometimes (after 2-3 years battery can have problem with contacts).
@RiceBerg
7 жыл бұрын
nice vid. all the vids I've seen show people routing hoses, which is great if you need to measure how much gas it's spitting out per min. But indidmt have any proper fitting tubes on hand and I just needed to test it mine was sucking up gas and handnt considered doing it this way and it worked great!
@davidsantiago6182
8 жыл бұрын
Awsome vid....if it wouldnt be for this video...the story would had been diferent...it started right away..thanxx for sharing and greatings from Puerto Rico
@blitzfultime
8 жыл бұрын
Tried this on my 01 but no motor spin just a spark.
@CWWest
8 жыл бұрын
Yeah that's what mine did when I first applied 12V power but after switching the power on and off a few times it finally broke loose. May try tapping it with a mallet to try and break loose the gunk if that is the problem.
@blitzfultime
8 жыл бұрын
yeah have tried to free it, this k1 spent the last 10 years sitting in a shed, rust in tank also, just hope internals are all good just ordered new pump for it and been pricing up some new tyres.:)
Пікірлер