Change the peck cycle so it doesn't fully retract it will save time and tooling wear!
@christopherbrown6152
Жыл бұрын
This is like watching old charlie chapman movies before actors talked
@mrt6399
Жыл бұрын
such an interesting machine
@starcatify
Жыл бұрын
It would be great if you could show how to create the Gcode for thread milling. Thanks!
@xyzspec82
2 жыл бұрын
Love your build 🤓
@VinnySmiles01
2 жыл бұрын
That seems extremely inefficient. A thread tap would’ve been done with both of those holes by the time that Threadmill got done with half that first hole.
@LeBearCNC
2 жыл бұрын
You are correct, but, in the same time, you are not thinking. A thread tap requires synchronization between spindle speed and Z feed. Not all CNC machines have that feature. AND, you need a thread tap for each thread diameter and pitch. On the contrary, a Threadmill does not require any synchronization,, and can be used for a range of diameter and pitches. It is slower, but it is a very budget-efficient solution.
@gangleweed
Жыл бұрын
@@LeBearCNC Plus the fact that you get all of the way to the bottom, and you never have a broken tap in the hole.
@norton750cc
Жыл бұрын
The tap would break at that depth@@gangleweed
@theofficialczex1708
9 ай бұрын
You can buy threadmills with drill tips to drill and thread simultaneously, then run a chamfer on the edge with the same tool. With something like a combination drill/tap, you need to swap out for different diameters. You must factor in even more tool changes if you're using dedicated drills and taps.
@davidschliebe246
2 жыл бұрын
That hole has to have a bunch of chips in it.
@pmsilvei
2 жыл бұрын
Did you mill the whole part in that machine? 🤔
@pmsilvei
2 жыл бұрын
What end mill? Subscribed!
@pmsilvei
2 жыл бұрын
Amazing! Out of the box design. Looks so good 😎👍🏼 Congratulations!
@CeNuVezi
2 жыл бұрын
Wonderig why ur end mill retract soo much after it been detected by height sensor , u dont need that retraction , with 0.5 mm can do the job ok , u need only na offset to measure again with low feed that is only what is doing .
@thetruthyouneedtohear
2 жыл бұрын
If he didn't retract fully, the endmill will crash when moving back to the part.
Very nice material removal for a home made machine. And very quiet operation. You must have purchased a quality spindle motor. 自家製の機械のための非常に素晴らしい材料除去。 そして非常に静かな操作。 高品質のスピンドルモーターを購入している必要があります。
@jonjon3829
2 жыл бұрын
Really nice setup, like dmf 200 from dmg. nice work. kzitem.info/news/bejne/kXtjxYZuk3mLn44
@hey.you.in.the.bushes
3 жыл бұрын
It was already threaded and damn the piece was so wobbly
Пікірлер