Dumb. Both valves must be closed for this to work ! DUH !
@philliphall5198
Жыл бұрын
Volume to low Can’t really hear you
@wcjcnc
2 жыл бұрын
Holy crap. Everything about this video is wrong. Hilarious
@tahoetom9932
2 жыл бұрын
How did you know your on the compression stroke? Sounds like your on the exhaust stroke.
@thesmallenginedoc4504
2 жыл бұрын
Later found out the mowers exhaust valve was replaced and they used the wrong valve therefore it didn’t get a good seat
@travismauldin7194
3 жыл бұрын
You been alright? Hope to see new videos soon!
@thesmallenginedoc4504
3 жыл бұрын
Yup just busy with school but more videos coming very soon
@TheLawnmowerLady
3 жыл бұрын
Good work! Keep the videos coming.
@travismauldin7194
3 жыл бұрын
Well done!
@ndubuisimbano9042
3 жыл бұрын
Also, my craftsman chainsaw starts and immediately dies. Help
@thesmallenginedoc4504
3 жыл бұрын
Sounds like fuel problem try replacing fuel line and filters if not it’s the carburetor
@ndubuisimbano9042
3 жыл бұрын
Don't let these devil's and haters get you down. They are like that everywhere. You're doing good. Keep practicing. The old guys at the shop here I still cat h them on you tube from tIme to time.
@danieldesimonedanny1827
3 жыл бұрын
The video is kinda long for the short attention span crowd. Good luck!!
@thesmallenginedoc4504
3 жыл бұрын
I’ve made them about 10 mins now because of editing
@RMartin631
3 жыл бұрын
You really need to take a class at the local community college in small engine repair. The coil isn't magnetized. The magnet is built into the flywheel. Coil clearance is pretty critical too in that the distance (clearance) determines timing and coil output. Also, don't bother talking about torquing to spec when you don't even have a torque wrench.
@thesmallenginedoc4504
3 жыл бұрын
I used a gasket because they are set at .008 which is the perfect clearance between the coil and fly wheel and I’m just 16
@oscarzshop2796
3 жыл бұрын
If you're the average old school mechanic who always hates on younger learner's. Then why the heck are you even watching THIS video if you are sooooo smart? 🤨
@oscarzshop2796
3 жыл бұрын
Anyways, awesome video.
@RMartin631
3 жыл бұрын
@@oscarzshop2796, I'm not hating on anybody. I know he's a young guy just getting started out. I pointed out a few things and gave some good advice. I came here to watch this video because I was invited here from a post that he made on Facebook. He needs to take a little of that money that he's earning and buy a set of feeler gauges and a 3/8" torque wrench from Harbor Freight.
Пікірлер