Yah to me when airbag light appeared, diagnostic tool quit working. Shit
@stumpedtree4204
2 ай бұрын
Bro went the extra mile here! This is what a bike shop won’t do. Respect
@stumpedtree4204
2 ай бұрын
Bit of grease back on the pistons before you push them in to fit new pads does no harm but this is professional!
@ed4778
4 ай бұрын
Excelente!!!! 👏👏👏👏👏
@marvindeguzman3011
4 ай бұрын
Thank you! I had a lithium battery replacement and worked fine but it shut down on me due to a short (the red cover) melted thru and touched the seat holder bar. I don’t know if I fried my system. I found this video to make sure I can check my rectifier and stators condition after. Ty!!
@arne857
6 ай бұрын
which of the oxford handles is it?
@sweetvelocitybps
8 ай бұрын
This is exactly the problem I was having with my 2016 FZ-07. You saved me what would have been unnecessary expense having a shop troubleshoot the problem for me. Thank you so much for this great helpful video!
@robcall5182
8 ай бұрын
no messing about, good video, and shows exactly what to do, thanks, next video? how to stop your shoes SQUEEKY on the floor.
@artyom188mph
9 ай бұрын
You should hold front brakes lever tight when you tightening up brakes to let pads lining correctly
@MT09spDARDY
10 ай бұрын
Loved how simply made it!! What torque setting did you use in NM
@zenden8030
Жыл бұрын
how many ft lbs did you tighten the bolts to?
@glaeser3626
Жыл бұрын
My front wheel doesnt spin as it should,it spins but doesnt make a whole circle it like does half circle then stops,is it possible that the problem is caused by the brake pads?
@CarlosGarcia-lx6qn
Жыл бұрын
Hello, it could be the brake pistons binding or your bearings are shot.
@glaeser3626
Жыл бұрын
@@CarlosGarcia-lx6qn the axle has nothing to do with it,right?
@gregorylagrange
Жыл бұрын
@@glaeser3626 Front may just have what's called a bearing spacer. Do you hear any noise from the front when it's rotating or when you're riding like a BB spinning around inside a can? There could also be some warping of the brake rotors if you have a lot of miles on them. But you should keep in mind that a motorcycle wheel won't spin freely from your hand spinning like you would expect a bicycle wheel to do. The loads and the lubricants are different for a motorcycle wheel and it's bearings.
@glaeser3626
Жыл бұрын
@@gregorylagrange i can hear the exact same noise from my rear tire as wel l but the rear spins smoothly and stops when it should,i have a feeling that the front loosens up a bit when motorcycle is started and sit on,brakes and everything else work fine idk if there is anything wrong with the front wheel or not but i dont think it should spin that hard no matter if the bike is started or not,btw during riding u can’t feel anything stopping the fromt wheel so.. but after droping it from wheelie u hear like a little scratch when the front wheel goes down idk if thats normal or not xd
@glaeser3626
Жыл бұрын
@@gregorylagrange thanks for answering xD
@abdotaher17
Жыл бұрын
Nice video, how many Nm did u fasten it with?
@mindvisionstudio7358
Жыл бұрын
Please can you link the red stand of your bike i want to buy same .. regards
@CarlosGarcia-lx6qn
Жыл бұрын
Hello its and Abba stand, it's pretty useful 👍
@soldiertype
Жыл бұрын
Nice.... I have the same issue as you. Im waiting to get this changed tomo. However I'm Getting check engine light on my dashboard. There is no code. What could be the issue? MT07 2015-2019
@CarlosGarcia-lx6qn
Жыл бұрын
Good luck, it would be very difficult to guess what it could be. Try with a diagnostic scanner.
@zireael666
Жыл бұрын
This was perfect! thanks.
@MeandtheB
Жыл бұрын
thank you! it helped me passing the MOT!! :D
@davidmelendez7328
Ай бұрын
I had the same problem,i change the airbag,the multiplex,etc and still on the f. light...and i dont have this pice down the stering,some indication about?
@stevepurves635
Жыл бұрын
You should put a light smear of copper grease on the back of the pads before inserting them.
@djkellyflavour5481
Жыл бұрын
Thanks for the video. Exhaust sounds good. Link please
@hstefan
Жыл бұрын
I will be doing soon a brake pad replacement on my friend's Tracer 700 which has very similar brake setup to the MT 07. I was looking for a brake job video but instead stumbled onto this. I now know exactly what to do. I thoroughly enjoyed this. Thank you!
@eyeanblue8374
Жыл бұрын
Nice! How about the rear brake change lol. Thanks for the video.
@lillashehata3723
2 жыл бұрын
Never thought I would find a video of a brake pad change satisfying 😂👍
@tekeristonline
2 жыл бұрын
Hello bro. I bought the bike 2nd hand a week ago and all of a sudden this problem started to appear, the problem sometimes disappears and sometimes it appears all of a sudden. In general, at the first start, the battery cannot supply enough electricity to feed the starter and I get a 5d 46 error on the screen. I suspected the battery but now I'm not sure if this problem is from the regulatoe or the cables going to the regulator. Can u help me please? What should i do? Should i buy a New battery or a regulator?
@CarlosGarcia-lx6qn
2 жыл бұрын
Grab a multimeter and test your regulator to make sure it is the faulty part, it should output around 14 volts DC with the bike running. All the best 👍
@tekeristonline
2 жыл бұрын
hey bro, I took the connector off today and tested it with a multimeter, the connector gives about 8 volts when the engine is idling, and about 11-12 volts at high rpm. I think the connector is faulty, I also tested the regulator, it gives about 23 AC volts from each output when idling, and it goes up to 100 AC volts at high rpm
@CarlosGarcia-lx6qn
2 жыл бұрын
@@tekeristonline it should output over 14 Volts DC so it can charge the battery mate. Good thing is you are getting closer to getting it fixed summer is close !
@mikew1084
2 жыл бұрын
Rubbis supposed to connected to ignition switch not to the battery if you forgot about them will drain your battery
@gustavofranchiose2472
Жыл бұрын
Oxfords one should go to the battery directly, it has a smart switch which turns it off in a couple of minutes when the engine is not running.
@medtazarh9390
3 жыл бұрын
Sd - - 15 ??
@nevermind7789
3 жыл бұрын
Yestarday I had problem with charging. Now I know how to check it. Thx from Poland
@CarlosGarcia-lx6qn
3 жыл бұрын
Zapraszamy. Hope you can get it sorted man, summer is just around the corner!
Пікірлер