That last part with the plastic sheet looks pretty tedious .. what was that last part you did there
@ofeliaorozco7909
9 ай бұрын
I need this on my 2017
@user-qo1ld2lp6o
9 ай бұрын
Я глибоко переконаний, що світом керують зовсім божевільні. Лев Толстой
@user-qo1ld2lp6o
9 ай бұрын
Дякую. Хороша ідея. Спробую. Бажано, щоб ніжки знімалися, зручніше буде зберігати. Кожна має свій ум голова.
@lonelybullet1
Жыл бұрын
Isn’t it less work to just replace the assembly?
@99names16
Жыл бұрын
Maybe. But it’s certainly gonna cost you $200-400. Beyond the money if they can be saved fairly easily it’s just An ecological waste to get new ones
@christianb6046
7 ай бұрын
Not everyone is technical enough to take this apart and then assemble it back.
@danieldavis6090
Жыл бұрын
My 16 I just got has hazy headlights, them low beams and making it through the lens lol. Considered leds until I could pick one of these kits up
@trentt559
2 жыл бұрын
Great job dude...🤜🤛
@vigilante9259
2 жыл бұрын
can we clean the lens inside? because mine isn't very clear so the low beams aren't bright enough
@ImperialistRunningDo
2 жыл бұрын
Bravo for using only hand tools! I am ashamed to admit, I will use table saw, band saw, lathe, planer and drill press. Ironically, I might use an old-fashioned brace and bit where you used cordless drill, so I get one point at least. What angle did you cut the bevel on the notch at?
Пікірлер