Yeah that grommet is lovely for an automatic... With manual the clutch cyl is in the way
@izayuhh1430
Жыл бұрын
what head unit do you have
@StevesLifeVLOG
9 ай бұрын
stock :))
@juhapeltola8232
Жыл бұрын
Just like the professional install 🤣🤣🤣
@KaurKadak-lm7jh
Жыл бұрын
Where did you took the remote signal?
@fredrikkerttula751
Жыл бұрын
After u cut the power cable at the hood, you filmed the L+ green cord stuff. Where are we in the car at this point 😅
@simonlinhein592
Жыл бұрын
Jävla sopor
@Morteexx
Жыл бұрын
That ground is really bad. But other job very good :)
@moonmonkey71
2 жыл бұрын
What about wiring in the speakers? Did you tap into them or cut and splice them?
@crazymix777
2 жыл бұрын
Whitepurple/whitegrey- right back speaker, white/gray-left back speaker wire. All left side trunk amplifer
@SamSam-ih7ds
3 жыл бұрын
Can’t find a video on how to take of the rear side panel.. guess i just have to figure that one out
@ruubentrooper8255
3 жыл бұрын
Where did you take the "rem/remote" wire from?
@VingMutt3r
2 жыл бұрын
The easiest way is to take it from the positive cable of the 12v plug in the mid console :)
@dylanc5222
Жыл бұрын
Otherwise you will have to take the orange/green wire on the back of the radio
@Cymons
3 жыл бұрын
Do you use the original stereo to do this? How?
@cheddarballs864
3 жыл бұрын
What fuse did you use for your remote wire? We keep getting a loud pulse when we turn the car on and off.
@ForcefulGaming
3 жыл бұрын
VIBE do a inline fuse for all sub and amp kits.
@cheddarballs864
Жыл бұрын
@@nicklauswolfram100 I believe it's due to the fuse we're using having power for about 30 seconds after the car is turned off. We have a switch now to turn the amp on and off but I will be fixing the issue completely soon.
@browskistorm1203
3 жыл бұрын
Where where the wires u connected the line output converter to
@zentarmuhammadi1198
3 жыл бұрын
word
@ajsexploration1232
4 жыл бұрын
are you seriously grounding to a painted surface? 😂😂
@sebastianericsson381
4 жыл бұрын
There was no paint under the screw😅
@sebastianericsson381
3 жыл бұрын
@@ajsexploration1232 it has worked for almost 6 months without problem
@sigurdolav5076
3 жыл бұрын
@@ajsexploration1232 No, you do not need to remove the paint. The screw will function as an conductor. BUT it gets a better connection when you get the paint away, and that will not hurt
@carloversworld6264
4 жыл бұрын
Nice video bro👍👍👍
@jonathanryden379
4 жыл бұрын
best video for c30 and v50 thank you so much. :)
@skouvaris
3 жыл бұрын
Only problem is that is where the clutch goes for a manual.
@lasertodd1346
2 жыл бұрын
@@skouvaris yes. Where can I get the cabel thru then...
@valkyrievolvo5460
2 жыл бұрын
@@lasertodd1346 there is a big fat grommet where a harness passes through the firewall to the engine component on the passenger side. You can access the interior side easily if you remove the glove box.
Пікірлер