What's the Carli Commuter Kit cost before install? Curious because I'm looking into purchasing an f250 but and want to get into a leveling kit or a small lift kit.
@danielanaya267
Ай бұрын
Did the kit come with radius arm brackets, the one I looked at does?
@bubba99009
5 ай бұрын
Did you just get the base commuter kit with the sway bar drop bracket and nothing extra from them for the rear? Looks like they really want you to buy their leaf springs for over a thousand bucks extra. Did you just put a block in the back? Did you get the caster shims? I hear those are needed to be able to get a good alignment. Just for that base config looks like it's $2500.
@bretthl1
3 ай бұрын
uh yuk yuk what's a castro shim?
@Steven-rg3hf
6 ай бұрын
Was the ready lift kit that you took of just the spacer version or the springs, shocks, etc. version ?
@Step-n-Wolf
7 ай бұрын
The lift kit makes the springs more rigid. I for one don't care about leveling . I would rather be able to carry a load and not blind oncoming traffic.
@akathedude3266
7 ай бұрын
have you upgraded your shocks? or added the sway bar or stablizers?
@paulmorris8061
7 ай бұрын
I ran Carli shocks with their track bar. Stock sway bar.
@dalthardtaylor8558
7 ай бұрын
So it was just the spacer kit not there 2.5" coil kit
@15dragking
9 ай бұрын
Get that tire off the bumper!😂
@casper24ism
10 ай бұрын
Ok im looking at the e venture kit 23k anyone have it does it drive 23k better
@jlcourtoreille343
11 ай бұрын
Did you go from a readylift with falcon level lift to a Carli commuter?
@jlcourtoreille343
Жыл бұрын
Did this kit have the falcon shocks?
@DouseAHouse
Жыл бұрын
I installed the Readylift coil spring level kit on my 21 F250,Rides much better than stock springd
@stevenstruwe5296
Жыл бұрын
How does a leveling kit contribute to performance?
@BrettSchilling
Жыл бұрын
What did you do with your factory wheels?
@malcolmn.5222
Жыл бұрын
Just go full dominator system!! Nice truck btw
@AaronMcQueen-b1v
Жыл бұрын
What did you do with your factory wheels?
@paulmorris8061
Жыл бұрын
In the shed at the moment.
@PaulHunter-de1oe
Жыл бұрын
i ordered wheels from custom offset and they came in damaged inside the box with no damage to the actual box. wheels where damage when package and still they haven't made it right!!!!!!!!!!!!!!!!!!! custon offsets is a joke of a company!!!!!!!!!!!!
@paulmorris8061
Жыл бұрын
Man I hate to hear that. Hope it gets squared away.
@PaulHunter-de1oe
Жыл бұрын
@@paulmorris8061 they are now ignoring my request to replace damaged rims. never do business with this company!!!!!!!!!!!!!!!!!
@charles17508
Жыл бұрын
Look s nice .
@TheMoneyBed
Жыл бұрын
I dig the honest review. Saved me from wasting money. I have the same truck and factory I get bump steer. So definitely not expecting a Raptor ride but my chevy 1 ton crew rides like a caddy compared to this f250. Love the Gt500, I have a Hellion TT s550 myself..
@paulmorris8061
Жыл бұрын
Thanks man!
@DJMEDIC671
Жыл бұрын
Ya for a level kit I have to say that cjc brand is a little in the high side.
@paulmorris8061
Жыл бұрын
It is but you get your moneys worth.
@DJMEDIC671
Жыл бұрын
I just installed the ready lift (2.5”) this past Wednesday. I feel that my steering feels better than stock. I don’t know if I need to break it in a little more. Yes on bigger bumps there is a tremendous notice on the steering that I’m not used to floating around. Then again this is my first super duty a hole another world to learn.
@ChokerTVMODIFIED
Жыл бұрын
Paul loved the video! Hey as long as you are shooting it don’t matter if you hit the target. It only matters when the target is holding a gun! Lol! Look forward to more videos!
@paulmorris8061
Жыл бұрын
Thank you. Haha touché.
@threatcadre
Жыл бұрын
Hell yeah....Will get you into a SRO before it is over with..hahaha...solid vid..thanks for bringing us along...
@paulmorris8061
Жыл бұрын
I like that plan. Thank you.
@think1stproductions
Жыл бұрын
That's not what she said lol😂😂😂😂 Red dots go hand in hand with ROBBING TITTIES... JUST SAYING..
@think1stproductions
Жыл бұрын
Hell yeah, I need to come out there with you and shoot some steel homie
@think1stproductions
Жыл бұрын
☁️☁️🔫☁️☁️🔫☁️☁️🔫
@think1stproductions
Жыл бұрын
🤔🚫🧢💯💪🏼🙏🎬⚜️📸🍺😈🥶☎️
@vj1715
Жыл бұрын
Thank you for this review. I was on the fence but will spend the extra money on the Carli.
@paulmorris8061
Жыл бұрын
It’s worth it.
@johnstuardo4895
Жыл бұрын
I just noticed that my passenger side tire is 3/4 inch further out than the right side, I hadn't noticed until today after 2 weeks.
@daytonfeiden6545
Жыл бұрын
You need a track bar or track bar drop bracket , Your axle isn’t centered
@paulmorris8061
Жыл бұрын
Track bar
@johnstuardo4895
Жыл бұрын
I am 100% agree with you. I have the same truck same trim and lift kit,not very happy, lower the tires pressure to 50 👍🏼
@paulmorris8061
Жыл бұрын
I already removed the Ready Lift spacer kit and put the Carli commuter kit. Night and Day! Loving the truck now. I did a follow up video to this one about it.
@Zj987654
Жыл бұрын
I installed the same kit on my 2020 F250. I optioned in the torsion sway bar with endlinks, add-a-pack leafs, and high mount stabilizer. I 100% recommend the sway bar, it takes a ton of that in-cab head banging movement out. I can’t really say the add a packs were worth it though yet, maybe a modest improvement at best to the rear ride. But overall I’d say the sway bar was the best addition out of all of them.
@JustDiesels
Жыл бұрын
The add a pack is designed to maintain capacity, but improve ride deep in the travel / on hard hits and remove the stock block to reduce axle wrap. It’s as good as you can get while basically keeping the same spring rate, but the big improvement comes from the full replacement pack.
@geraldmcclintock2567
2 ай бұрын
I didn’t like the add a pack. Too rough. I went back to full progressive and added air bags for towing. The sway bar is a good addition.
@trentherring5640
Жыл бұрын
So, how much lift does it actually provide on the front? What is it listed as when you buy it?
@paulmorris8061
Жыл бұрын
3.5" in the front on 2020+
@dantimber
Жыл бұрын
Wife's approval. Priceless!!!
@martinscores-easy1066
Жыл бұрын
Truck Looks Sweet...!!! Good Honest Review...Thanks Paul.. Convinced Me To Go Carli.....
@rwillisny38
Жыл бұрын
Thanks and carli kit is what I’m going with
@wcovey25
Жыл бұрын
Love the truck, subbed
@paulmorris8061
Жыл бұрын
Thanks for the sub!
@rubenzamora9960
Жыл бұрын
Good video. By any chance can you post up what blocks you installed in rear?
This is the one I used. It will give you a slight rake so when the truck is loaded it will sit level. If you want it level all the time they recommend the 3.5” block found on the Tremor.
@ChokerTVMODIFIED
Жыл бұрын
Great video Paul! Love the truck! Love the upgraded suspension! @ChokerTV Modified 👊🏾
@paulmorris8061
Жыл бұрын
Thanks 👍
@kingranch8516
Жыл бұрын
Thanks for this bro. I will prepare to sell a kidney so I can afford the carli 😉. One thanks
@paulmorris8061
Жыл бұрын
Part 2 is coming out tomorrow.
@jadersaid50
Жыл бұрын
my brother congratulations your car is very good. here in Brazil is very expensive. but Jesus Christ will bless me with a machine like that Ford. Jesus Christ bless you brother Paul
@malcolmn.5222
Жыл бұрын
I have had a spacer kit before on a previous truck and It did not improve the ride. My next ford truck will have the Fox 2.0 leveling kit.
@ChokerTVMODIFIED
Жыл бұрын
Loved the video! Look forward to seeing more!
@paulmorris8061
Жыл бұрын
Thanks brother!
@Mill72
Жыл бұрын
You get what you pay for.
@joshuawilliams6321
5 ай бұрын
Sometimes you overpay for shit too!
@nicholasbrown7068
Жыл бұрын
Most guys that I know (me included) would prefer this and keep our trucks factory springs since we use our Super Duty's for plowing snow.
@Rhinopkc
Жыл бұрын
Front Timbrens or Sumo Springs during plow season let you have a nice riding front spring the rest of the year.
@williamedwards6496
Жыл бұрын
I ran this kit on my 22 F250 7.3 - I did the Frankenstein kit with it. I ran the 2.5 Ready lift level with the adjustable track bar. 2 Degree castor shims didn't work for me either. I added Bilstein 5100 on 4 corners and then did the PMF steering stabilizer with the 5100. To fix the castor issue I ran the PMF Radius arm drop bracket. Had little bit of positive castor but ran great. Its sold now and have a 22 Ram that has a 4in and 35s. Just didn't need that size of truck in the end. Nice video looking forward to see what you do next!
@paulmorris8061
Жыл бұрын
Thanks! Working on part 2 now. We pulled the spacer lift off and put a Carli commuter kit back in its place. Night and Day!
@mikes1292
Жыл бұрын
Wheel and tires look awsome man! Did u end up putting ceramic coating on them?
@paulmorris8061
Жыл бұрын
I did and it really makes a difference in appearance. I used G techniq on recommendation from my detailer. It's not cheap but so far I'm impressed.
Пікірлер