How did you define concrete material in property Could you share it with me?
@wijerathnenk
3 жыл бұрын
I want to model the two steel plates and wrap the CFRP material around it. I need to create a bond between the CFRP and the steel plate Need the ANSYS Simulations. I have the drawings of those 2 steel parts from SOLIDWORKS. Can you help me? Please drop your email to connect with you for more details. Thankyou.
@aljarrah1233
3 жыл бұрын
Could you share python file, please !
@ingridrocioirrenopalomo8254
3 жыл бұрын
There is any way to active CRFP only after of apply the load in the element? I understand that this type of retrofit acts before to be applied the load!
@navneet214
2 жыл бұрын
I think it could be done in steps, but what do you mean this type of retrofit acts before ? Due to the bond, the system will behave together.
@vishantshah67
3 жыл бұрын
Sir can u help me in this ABAQUES !? I have to do same thing in ABAQUES but with different meterial I don't get answer so please contact [email protected]. Thanks
@amrabdullah1995
4 жыл бұрын
Hello sir why did not you use hashin failure for frp ? instead you used failure stresses... any explanation would help thank you great work
@navneet214
4 жыл бұрын
It is mainly on account of two factors 1) Hashin Failure criteria required specific testing data which I did not have. 2) Failure stress gives more or less accurate results for my conditions it was verified with existing studies so I decided not to spend additional time.
@amrabdullah1995
4 жыл бұрын
@@navneet214 thank you for the reply. do you have any experience in modelling of pipes under internal pressure and FRP with hashin failure ? i have some questions if you dont mind. you may give me your email. Thank you alot
@nomi8483
4 жыл бұрын
How did you get the material properties of CFRP, would you please share the article or reference for it. I am also using CFRP in my simulation but I don't know how to get all the required properties.
@navneet214
4 жыл бұрын
I had used material technical data sheet provided by the supplier of CFRP
@navneet214
4 жыл бұрын
Though there are many references which have these properties, you can check FIB ( bulletin 14 I think but I am not sure )
@pranjalshelke588
3 жыл бұрын
Can you model FRP Wrapped concrete column using ansys
@ugohogbechie5863
4 жыл бұрын
Please, i need details for application of CFRP on simply supported slabs.
@umerfarooqkhalidmirza2775
5 жыл бұрын
What are the units of work done.like if you chose depth 2400 what is it mm inch cm what and why you didnt run it
@navneet214
5 жыл бұрын
I have taken all dimensions in mm, however ABAQUS is not specific to any unit. Also I did run it, it takes 1-1.5 hours to run on my computer. Hence didn't put the results.
Пікірлер