Welcome to Maritech FAS Systems...we post "How To" videos on Fire Alarm and Security Systems. Our videos will be educational in nature from new installations to troubleshooting and service.
Trying to change out a bad smoke detector. Do I have to enable mapping to clear the troubles of the new device and the missing device.
@savemyneighborhood
5 ай бұрын
can I disable a mapping on EST3 for unconfigured devices to clear the unconfigure device after replace smoke detector device?
@julieespanol6126
10 ай бұрын
Good days,how to clear the software error faults io500.thanks
@malurys9194
2 жыл бұрын
I plan to disable mapping after installing a SIGA Smoke detector. Are you confident that the detectors are still supervised and will go into alarm as needed? Computer not available right now.
@stevenzucker7984
2 жыл бұрын
So the mapping is for the tech troubleshooting later on as it only shows the physical wiring connections…once all SLC devices are installed AND programmed, you must test and can disable mapping. A benefit to mapping is quick device replacements. A laptop is NOT necessary and you can keypad program the system
@Sdifirealarms
3 жыл бұрын
hello I have the same panel and the screen appears "status 3c0003" do you know what it means?
@theboys993
3 жыл бұрын
If you happen to have a moment, I have a question regarding the io64 and could really use a few seconds of your time.
@stevenzucker8622
3 жыл бұрын
you can call me, 954-534-6685
@jesserodriguez3698
4 жыл бұрын
We are having a problem on finding a ground fault on an IO that comes on every time it rains, then eventually. Goes back to normal once all dries up????
@stevenzucker8622
3 жыл бұрын
unfortunately, that is clearly water leaking into a conduit somewhere and draining. The only way to fix it, is jump on it the moment it happens. I would look for outdoor NAC devices
Пікірлер