What, no linkert? No adjust for the fun of it, no cool nostalgic bird deflector. Motor cold,lever to choke and kick once or twice. Then ing on, carb lever to start, kick start. If you want a mikuni ride a Yamaha. Its a side valve, it's going need a menhanic, all new looking parts and no linkert.
@fredsgarage6078
3 ай бұрын
Hello Calvin The linkert was installed after the initial startup. This was simply to check that the engine would start. However, I would say that I believe that there are no wrongs in this debate. Some like originals and prefer linkerts and others prefer Mikuni.
@dogpaw775
10 ай бұрын
plates that need a mallet to be inserted are not going to move freely.
@frankfurther3828
Жыл бұрын
Great vid. What are we using to clean the plates?
@fredsgarage6078
Жыл бұрын
I always use brake cleaner. I can buy it in 5l bottles for cheap and it works really well in situations where I'm not interested in using soap and water.
@frankfurther3828
Жыл бұрын
@@fredsgarage6078 ok good, just now I see that I need a sleeve to install the clutch gear seal.
@frankfurther3828
Жыл бұрын
@@fredsgarage6078 My hub has the ball bearings. I see some guys have rollers.
@fredsgarage6078
Жыл бұрын
@@frankfurther3828 I've been told that the ball bearings are the original and the rollers are used with worn parts where the balls have made a groove in the parts.
@frankfurther3828
Жыл бұрын
@@fredsgarage6078 Thank you for the information
@marcussellers9512
Жыл бұрын
Zoom your camera out mate hard to see
@fredsgarage6078
Жыл бұрын
It's a good idea. My current setup don't allow for that, but I'm hoping a new setup with multiple angles will make the videos more pleasant to watch.
@jimbaker4277
Жыл бұрын
You made me yell at my computer at 5:36
@fredsgarage6078
Жыл бұрын
Believe me, so did I when I edited the clip.
@charlesgreene8236
Жыл бұрын
Thank you for this series. I have been working on my late Grandfather's 1942 45ci solo over the past few months. Just completed the transmission and your clutch assembly and carburetor video's are the next step for me. Very helpful!!! Congratulations on achieving your first start!
@fredsgarage6078
Жыл бұрын
Hi Charles. Thank you for showing your appreciation on the content. I try to make videos that I would enjoy watching myself. I am by no means an expert on the 45s, but please feel free to ask questions in the comment section. That way I or other viewers might be able to help you out.
@Junior-bz8or
Жыл бұрын
𝐩𝐫𝐨𝐦𝐨𝐬𝐦 💪
@edpazikas8777
2 жыл бұрын
The steel plate is incorrect, it should be facing the other way. Please refer to the original steel plates with the mark OUT.
@fredsgarage6078
2 жыл бұрын
Hi Ed Thanks a lot for noticing this. I noticed it as well after editing the video. That's why I put it in the subtitles. Cheers Fred
Пікірлер