Buy cheap buy twice! But for the price they sell them at you can’t really complain about them. I would only buy these as temporary use
@kevingoldbey7401
Жыл бұрын
Dirtbirds
@Tooma1979
Жыл бұрын
I can’t get my driver side back in any advice there’s no c clip
@Hauuy-el1vv
2 жыл бұрын
Personally I think the uprated shafts they offer for £170 per pair are alright for the money. I'm running 300hp on mine and 400Nm+ of torque. I gave my set a good beating for around 2 months and whilst they were clunky, they didn't break. Considering the price, they did a lot better than I expected. If you're going to drive very hard, you'll break OEM shafts so might as well buy cheap then it's not a big deal when you break them
@drawmcgraw9653
3 жыл бұрын
Thanks dude good help. Nearly bought one
@bahcoboy7690
3 жыл бұрын
Fuck. I just installed those. I hope they work. Someone said they last over 3 years so no problem then..
@dynoguy
4 жыл бұрын
I should have watched that 2 weeks earlier, .. not impressed with these guys either. Sent entirely wrong part, exchanged it and the new one looks different but does fit at least, quality is rather questionable, outer joint feels a bit odd when moving around. Packaging was one of the worst i've seen so far. The other side (short one) looks wrong, too but they telling me that's the only one they sell for this car and it fits all (Auto and manual), which is a joke. Yes, it does (sort of) fit, but dimension are different, it sits further out from the gearbox which puts extra stress on the bearing, also had to machine a bushing as the diameter after the spline is too small, therefore lacking support in the transmission which will most likely cause excessive vibration. These guys are a just a waste of time and money as i''ve done every side twice because it's my daily driver. As usual, you get what you pay for. As long as they last until i properly refurbished my original ones, i think i have to live with it. Perhaps i'd rather be a bit careful on the throttle until then. Mine is a Volvo V50, uses the same shafts as the Focus and C30. Video will come soon.
@veoverse4286
4 жыл бұрын
Did your driveshafts from j&r fail by now?
@dynoguy
4 жыл бұрын
@@veoverse4286 Well, i ended up using only the R/H one from them, the L/H one turned out to be a few mm too long, so i used a different supplier (which was not exactly the correct one either) . I you look at my Volvo playlist, there is the full story. Only got around 1200 miles on them right now , still doing OK, but i can feel that the joint is still a bit stiff when cornering.
@veoverse4286
4 жыл бұрын
ok thanks for the feedback🙂
@christopherhart2045
4 жыл бұрын
Total rubbish products and services offered by J & R driveshafts, totally agree with this review. Scheming company that provides false services, avoid them people they ain’t worth half the money they charge !
@Tooma1979
4 жыл бұрын
Just bought two off eBay £33 for passenger £27 for driver side free delivery says 3 yr warranty on the box they are brand new, our Ford Focus mrk2 has done 180,000 miles on the original one I’m not expecting the whole car to go another 40,000 before we scrap it hopefully these along with the new gearbox oil will last until it makes it to 220,000
@vallancesmillie5734
4 жыл бұрын
Its will last 6 months at best .trust me been there .2 nearside and 1 drivers.
@Tooma1979
4 жыл бұрын
vallance smillie still waiting to fit them I will come back and let people know like I have stay safe buddy
@vallancesmillie5734
4 жыл бұрын
@@Tooma1979 finger crossed, they failed the same side everytime.hope it works out.
@veoverse4286
4 жыл бұрын
Did you had any problems with the driveshafts by now? I wanted to change mine tomorrow since i allready have them... or is it better to by a other set? I dont want to change it after a few months again😒
@Tooma1979
4 жыл бұрын
GermanBass their still in the box in the garage lol sorry buddy cars not moved in six months they defo need doing before the mot nxt month
@thetaylor82
4 жыл бұрын
So let's get this straight. You lied about nearly everything, then when they have an early death you feel resentment? Sure, they might not be up to much. But you're hardly in a good place to leave anything other than a biased review.
@tracieoliver2307
4 жыл бұрын
Chris you dont say how much your car is uprated by? you need to take all these factors in when clearly indicating the shafts are poor! you need to clarify if your car is standard and not uprated and better still what power you are running. Also being a Engineer it is clearly a factor that if your bushes or other suspension components are worn this can equally shorten the life of driveshafts even the clutch and mounts can play a big factor in shortening the life of a driveshaft! To sum up I have fitted J&R Shafts many times and as yet no issues have occurred so please can you post what power you are running,if your car has been lowered, and if all the other suspension components are in top notch condition and are you running with uprated clutch and mounts Thanks
@veoverse4286
4 жыл бұрын
Still no issues? I am going to install my j&r shafts tomorrow
@tracieoliver2307
4 жыл бұрын
@@veoverse4286 Indeed no issues yet and have done 8000 miles!
@deanoscott
3 жыл бұрын
@@tracieoliver2307 I fitted j&r shafts to my modded fabia vrs (200bhp and 310lbft) and they took a helluva lot of abuse. Sold it 3 years ago and still going strong.
@johnspeedfight2
5 жыл бұрын
I built a set up just like this and it works, Am running the same £30 pump, pressure operated switch £20, in the end I had to buy a genuine aem injector because it was the only way I could get the correct spray/ mist pattern, seems to be working fine on my 400bhp 2.0 gt28 (z20let) engine.
@TNotoriousAdam
4 жыл бұрын
what pressure switch did you go for?
@marcustaylor7806
5 жыл бұрын
What do you expect when paying less than half the OEM price?? You get what you pay for. Don't be tight pocketed with your car lol.
@samvaldez7670
5 жыл бұрын
What anti siphon solenoid did you use?
@UA-mu9bz
5 жыл бұрын
What’s your opinion on q-drive driveshafts
@davecozzie1
5 жыл бұрын
I have just had mine long shaft replaced but its not tge j r one. It was £90 + vat found out an hour later i still have the clunking sound from set off and turning checked the left short shaft in theres in out play in that gen one. I have a gen short shaft im replacing in the next hour hope it fixes it drives me crazy when my car isnt right. Thanks for the vid. Theres not many vids on youtube with the focus st225s its a shame
@chrism4081
5 жыл бұрын
Good luck, ive found Genuine Ford/Volvo to be the most reliable. Also I found this site offering good price refurbs on exhange: www.carpartsexpress.co.uk/ST-Range/Focus-ST-Facelift/Transmission/Driveshaft--CV-Boots/Focus-ST225-Driveshafts/p-1805-1810-1834-1902-845/
@davecozzie1
5 жыл бұрын
@@chrism4081 oh really? That would be a better option. So i changed the short shaft and im sorted now im just wondering how long the none gen long shaft will last. Im currently on a stage2 map frs injectors 1.2bar boost intercooler induction lets see how long it lasts lol
@chrism4081
5 жыл бұрын
@@davecozzie1You will have to be careful, its the low speed torque that kills them. Drag-race starts from traffic lights and wheel hop are the best way to break driveshafts. Top end power isn't an issue
@davecozzie1
5 жыл бұрын
@@chrism4081 surely theres some shafts capable of handling a mapped focus st..? What about focus rs shafts?
@chrism4081
5 жыл бұрын
@@davecozzie1 Focus RS mk2 has a different subframe, hubs and driveshafts. You can convert your ST if you like, but its not very cheap. OEM Ford or Volvo shafts are fine, as long as you aren't shock loading them with drag race starts or wheel hops.
@929cosmodude
6 жыл бұрын
im running a very similar setup same pump and solenoid, and running a brass 0.6mm misting nozzle for about 150cc/min you can buy the misting nozzles off ebay for around $3-$4 for a pack of 10
@trueillusionmusic9352
6 жыл бұрын
Very helpful and perfect timing for me, I currently have 2 standard J&R shafts on mine and was half considering the uprated ones shown in this video, but ill get Ford now - it's clear these are just as useless as the normal ones. I agree the warranty is useless, their warranty is basically "oh we'll send a new one if you can prove its our shaft". Problem is unless you're a mechanic, you're spending out labour every single time you have to take it on and off. And why on earth would I want to put another one of these on !? On my car there is a vibration coming through the floor at 2000 - 3000 under acceleration/torque delivery ... I bet you a tenner, if I removed mine ( which i will be ) the joints would have play, just like this video. They click now as well, when reversing or turning. I am pretty sure, if enough people pushed this they would have a case against them on the grounds of it not being fit for purpose. In my opinion they appear to be cheap cheap shafts, and aren't up to the job.
@chrism4081
5 жыл бұрын
I found a cheap OEM shaft refurbisher and will be using them again in future www.carpartsexpress.co.uk/ST-Range/Focus-ST-Facelift/Transmission/Driveshaft--CV-Boots/Focus-ST225-Driveshafts/p-1805-1810-1834-1902-845/
@centsam7
6 жыл бұрын
I bought these updated ones about a year ago over the phone and one broke after about 2 weeks and they sent me out another one the next day and it's never gone again, maybe they don't actually uprate all of them and try rip some people off by sending them the shit ones, seem to be holding up fine atm checked them last week and they have no play at all, going on track next week so I'll see if they last after that (lowered and mapped)
@chrism4081
5 жыл бұрын
I didnt get anywhere on the phone with them. They told me my car was lowered, that it wasnt for anything but standard power cars, and when i denied all that, they said no warranty on uprated parts. I looked on their website for this statement in their returns policy - but I couldnt even find the returns policy itself!
@veoverse4286
4 жыл бұрын
Did you had any problems with the driveshafts after that? I am going to install mine j&r tomorrow and need to know if i better buy other ones?
@uhhhhh262
6 жыл бұрын
Ebay parts! Love it
@gandi69
6 жыл бұрын
Yeah their products are dog shit. Probably chinese tat, i wonder if you spoke to the same idiot @ j&R I did as they never will honour any warranty stuff. Total rip off company in breach of consumer goods act
@chrissantos7878
6 жыл бұрын
So what every happened to this project? Did it work?
@HPVIDEO10
7 жыл бұрын
Please share the code>>>>>>
@ExposedUKDashCams
8 жыл бұрын
Hi Chris, would I be able to use this in my weekly dash cam compilation series please? Credit and links will be provided as standard. Kind Regards
Пікірлер