yeah that was brutal...12 wasted exposures and no audio commentary lol
@terrymartin9642
3 жыл бұрын
I have sketched out a method for reloading 35mm film onto 127 (or 120) spools. I have a couple hundred feet each of Agfa Copex Rapid and Agfa 400S in UNPERF to experiment with until Ilford again allows custom cut orders. In a 127 camera, 35mm wide film leaves about ¼ inch top and bottom of the frame unused, and about ¾ of the area of a full 127 frame. The negatives would be about 46mm wide and 35mm high in landscape. Perf’ed film could be used with shorter frames. Of course, 120 film could be slit to 46mm and the flap mechanism below could still be used effectively. Two spools are needed, as well as film cut to length and the backing paper. For attaching the takeup end of the film to the takeup end of the backing paper, I have tested taping a 1 to 1-1/2 inch piece of 46 mm wide backing paper to the 127 backup paper at the location where the takeup end of the film would normally be taped to the backup paper. This creates a flap. The backing paper is wound tail end first onto a supply spool until the flap is exposed. The measured and cut length of film start end is inserted under this flap (at the point about 3/8 inch short of the original tape) and the film wound in takeup mode on another spool just as it would be wound into the camera. When the free (tail) end of the film is reached, it is tucked under the tail end of the backing paper and the film/backing paper combo is rewound onto the supply spool. When the start end of the film buckles up (due to the different length of the film and backing paper spirals) and reaches the flap, the beginning end of the film simply slips forward under the flap. The film is now ready to be used, properly spooled without the bump or buckle. As the film is initially fed into the camera, the flap prevents the film from catching on anything; the flap grips the film which simply follows along as it is wound into the camera. This is a heck of a lot simpler to do than to describe it. Terry
@bartwaggoner2000
3 жыл бұрын
did i just sit through 12 exposures? ;-)
@user-yv2cz8oj1k
4 жыл бұрын
I take it you mean 120 film, re-cut to 127.
@retromata3941
3 жыл бұрын
it's 35 film rolled into 127 spool, using recut 120 backing paper
You should open the top to access the viewfinder if you want to see something.
@jean-philippefahrni8415
6 жыл бұрын
Looks like you are using a rolleiflex for the first time in your life
@acidsnow5915
6 жыл бұрын
Great video of a beautiful camera. Always love watching good videos about hasselblads. Really dont get tiered of them
@IainHC1
6 жыл бұрын
But then..... I'd re roll it all back using another spool so the roll starts at the start and the numbers on the backing paper are all correct.
@retromata3941
6 жыл бұрын
couldn't be more agree with you
@livelongandprosper70
5 жыл бұрын
@@retromata3941 fuck you !
@AJC420
6 жыл бұрын
What model is this?
@retromata3941
6 жыл бұрын
K5 with 3.5 Xenar lens
@ariefwirawan
6 жыл бұрын
Dapatnya berapa frame mas kalo di modif seperti itu?
@retromata3941
6 жыл бұрын
sekitar 26 frame kayaknya mas.. lupa saya filmnya juga udah entah kemana
@ariefwirawan
6 жыл бұрын
thxs infone mas
@theonlygoggin
6 жыл бұрын
Although I can't understand a word, this is the best way I've come across for loading 35mm in a 120 camera
@retromata3941
6 жыл бұрын
thank you :)
@pasty_film_journey
6 жыл бұрын
Why would you want to load 35mm into a 120 camera? I've never seen this done before. I could imagine it been used as a panorama, but then wouldn''t it be easier to use 120 and crop?
Пікірлер