I'm thinking about painting the heater element tube with high temp paint to keep it from corroding where the metals touch. Thoughts?
@pedropablodiazangel317
4 жыл бұрын
good morning could you help me please? I need the thermostat of the cuisinart DCC1200 coffee machine, you know where I can buy it. thanks very much.
@robertcomeault8266
4 жыл бұрын
What kind of gb weld did you use?
@dukemd69
3 жыл бұрын
J-B WELD
@MrDanielbly91
5 жыл бұрын
how did you get the bottom off without damage.
@achilles3712
5 жыл бұрын
daniel bly I had to drill the screws out and I can still can only get the bottom half off, I’m afraid of snapping it
@cap4life1000
4 жыл бұрын
I'm trying to tear this down now. I bought the security bit. The screws in the short section came out. The screws that are in a probably 3 in tube on the back of the machine are spinning but not loosening. Any tips?
@anthonyfigueroa1288
4 жыл бұрын
@@cap4life1000 were you able to fix the coffee machine? Mine just started leaking last night.
@cap4life1000
4 жыл бұрын
@@anthonyfigueroa1288 mine was not leaking. But I wanted to clean out the bottom sections. I found that the screws functioned properly. My problem was caused by the diameter of the hole leading to the deep screw. All of my extensions were too wide to get the bit down to the screw. I ended up dropping the bit down in the hole and making sure it seated in the screw. Then I put the extension down as far as I could and rotated until I could align with the bit. The added distance of not having the bit fully seated in the extension allowed me to get the screw out. Hope that helps!
@aagot756
5 жыл бұрын
*Most of the unit is stainless steel, as well as the carafe.>>>**t.co/plDwEzh4TX** I broke so many glass ones, this is such a treat to have a sturdy, unbreakable one. It also doesn't drip as I'm pouring. Such a high-class profile of a coffee maker, too. LOVE it!*
@marywu4207
5 жыл бұрын
I need help on DGB 900BC operations -- Start/ON/Off button and GrindOff buttons won't activate. Can I mail it to you for repair?
@gddeen1
3 жыл бұрын
Mary, what did you do with your coffee maker? I found after 10[???] years or so it plays dead. Everything works, but sometime it won't show power. Possibly power supply. I AM going to fix mine. If it is the power supply the fix is simple. If it is the microprocessor I will have to program an Arduino controller and wire it in [No problemo]. But, I am curious how yours died.
Пікірлер