I thought that Torque wrenches were supposed to be not used for loosening as it could upset the calibration, it is printed on the wrench. Scaffy bar on a toeque wrench?
@michaelgarner9816
4 ай бұрын
Should have used a breaker bar.
@jordivandijk1797
5 ай бұрын
Bedankt voor de nuttige video, waar heb je de nieuwe asmoer en stofkap gekocht :)?
@Gildesio
Жыл бұрын
muito bom o serviço meu caro.. parabéns.
@carlomahony3016
2 жыл бұрын
Hi where did you get the little rubber support that you put on the jack and do you have a name for it and link thanks
@washy5851
2 жыл бұрын
No instruction on winding the piston back into the caliper and no information on the torque setting for the rear hub nut. Using a length of scaffold pole to tighten the hub nut. ARE YOU SURE???
@davidsimpson1275
Жыл бұрын
Will this be the same brake set up as a citreon ds3
@cristobal1918
2 жыл бұрын
friend could you make a video on how to check the hoses and vacuum valve, I have a 308thp and I think I am failing (p0299) or maybe it is the turbo actuator I do not know. great videos crack
@cristobal1918
2 жыл бұрын
@Nigasan Koneswaran and where is the seesaw?
@ozon-on4495
5 ай бұрын
Please tell me tightening force of the screw securing the discs and kind of grease that used.
@michaelgarner9816
4 ай бұрын
Depends on size. The one with a 36mm nut needs to be 300N/M but the version with a 32mm nut should be 210N/M. You should only use copper grease around the brakes but specific slider lube/grease for the sliders. When you watch the part of the video with him wire brushing the axle stub beware of damaging the small black plastic ABS sensor.
@ozon-on4495
4 ай бұрын
thank u
@maciejwu71
Жыл бұрын
Tragedie!!!
@michaelgarner9816
4 ай бұрын
Some take 32mm socket to remove the hub nut and that isn’t how you torque up the hub nut.🫢
Пікірлер: 14