Chrysler outboard remove flywheel set points test Condenser
The crank shaft has a little straight mark and when the points move around to this you set them.
.040 is the points gap
Once you set them just spin it around couple times and recheck them.
The mixture screw is about 1 1/2 turns out to get ya started and work in slow to lean it out.
Disclaimer:
Due to factors beyond the control of Random Things Are Best, I cannot guarantee against improper use or unauthorized modifications of this information. Random Things Are Best assumes no liability for property damage or injury incurred as a result of any of the information contained in this video. Use this information at your own risk. Random Things Are Best recommends safe practices when working on vehicles and or with tools or cooking or Riding Motor bikes or ATV or over things seen or implied in this video. Due to factors beyond the control of Random Things Are Best, no information contained in this video shall create any expressed or implied warranty or guarantee of any particular result. Any injury, damage, or loss that may result from improper use of these tools, equipment, or from the information contained in this video is the sole responsibility of the user and not Random Things Are Best.
#Chrysler outboard #points #flywheel
Негізгі бет 10hp Chrysler outboard remove flywheel set points test Condenser
Пікірлер: 10