WOW you are blazing thru the restoration Good Job!!! Love your videos, Thx for making them
@themiddleagedgoodtimers4768
2 жыл бұрын
No problem, thanks for watching!
@STFautoclassics
2 жыл бұрын
Awesome work,I just found your page and following along as I'm restoring a 65 also.
@themiddleagedgoodtimers4768
2 жыл бұрын
Cool, good luck with your project and thanks for watching!
@randywright4310
2 жыл бұрын
Thanks for all the clues
@themiddleagedgoodtimers4768
2 жыл бұрын
No problem, thanks for watching!
@nicholasbrown6481
2 жыл бұрын
You can use an engine hoist to lift the body. May be easier than using a jack
@yepyep340
2 жыл бұрын
Im telling ya your going to need to fit the engine and trans before any body work. Tunnel is going to be necessary. I had my LS engine ( lq9) in and out several times.
@yepyep340
2 жыл бұрын
you should see mine. Im in LA California
@themiddleagedgoodtimers4768
2 жыл бұрын
How bad was it?
@yepyep340
2 жыл бұрын
@@themiddleagedgoodtimers4768 go with Pontiac engine to 350 chevy motor mounts OPG had them.. get plates to stack under those. I had several thickness to play with. they cantalever over the front of the K member a bit. Plats/shims under them I cut. Moroso has some for Chevelle A body cars, but they suck. Then 350 short and wide motor mount to the Ls plate. If ya go with something like muscle rods then ya get a lot of vibration. I do not like sold mounts. Tunnel turned out sweet,(4L65E) but less room for gas pedal.Your probably (4L80E) Im drive by wire. Lokar cable pedal is not comfortable for me. I was able to move my stering shaft over a little so my Dougs header do not need any Black smithing. Fit good. But headers are always hit and miss. Leave the front clip off for mock up. then take it out for paint. I work on peoples old shit. When I'm out in my garage I like to work on something that looks good. so I painted it first. beer taste better drinking it next to a good looking 65 GT0. CHEERS!
@themiddleagedgoodtimers4768
2 жыл бұрын
True indeed, thanks for the insight.
@anthonycordova6076
Жыл бұрын
I’m in Chino California and I’m about to start my 65 GTO. The channel makes me want to do it myself but I want to finish at some point so I might outsource. Cheers guys!
Пікірлер: 13