This video is an absolute life saver for me! I’ve got a 1997 25hp evinrude that I need to replace the side motor mounts. Never knew there was a front mount!
@SRadigFishing
3 жыл бұрын
I actually broke my front mount thinking it was the tension adjusting nut! (oops) Won't do that again, I love this 25 and am looking for a small boat for it now.
@SRadigFishing
3 жыл бұрын
If I remember right, the front mount was hard to find and when I got a Chinese copy it was metric. So I had to make a trip to the hardware store for metric nuts. I don't know if I said that in the video. Good Luck.
@ajeschelweck362
3 жыл бұрын
@@SRadigFishing I actually checked my lower mount after watching the video and sure enough, she’s shot. I could only find one used one on eBay for $80! Might call around to local Evinrude Johnson shops and hope they have a parts motor sitting around with it. I’m hoping there’s someone out there that has figured out a good replacement substitute for it if I’m out of luck. Beyond the motor mounts it’s a great motor! Starts first pull every time!
@ALVintageOutboards
Жыл бұрын
I have a 1975 Evinrude 9.9. Do i need to pull the powerhead to replace the upper center mount?
@TimeToEatTheBait
Жыл бұрын
Not sure on the 9.9 Haven't seen one to be able to say.
@SRadigFishing
Жыл бұрын
@@TimeToEatTheBait I can't remember where I got the mount from might have been eBay, but it was a chinese copy and wasn't quite an exact fit. Some of the motor parts are no longer available.
@powellc2232
2 жыл бұрын
Thank you for this video. Do you know how much torque you used to reinstall the mount bolts and nuts?
@SRadigFishing
2 жыл бұрын
Guessing between 10 and 20 ft/lbs. with lots of non hardening locktite!
@powellc2232
2 жыл бұрын
@@SRadigFishing thank you!
@ANVICTA
4 жыл бұрын
Nice job can you tell me if the read fish are back in the river yet
@SRadigFishing
4 жыл бұрын
I have not caught any reds yet but I will be checking again later this week and will post video of results.
@ANVICTA
4 жыл бұрын
@@SRadigFishing thanks 😊
@jeffreypavon2058
4 жыл бұрын
What kind of boat you putting the motor on ?
@SRadigFishing
4 жыл бұрын
Don't have a boat yet, looking for about a 14 foot jonboat or skiff.
@jeffreypavon2058
4 жыл бұрын
I’ll go with a 15 ft v bottom Jon sometimes you might want to make the run for bigger bays can’t go wrong. That’s what I got with a 25 Yamaha
Пікірлер: 16