WoW this is an old post! Don’t know if the author is still watching but just in case - thank you. The cord inside the neck seems an excellent tip. I’m going to try that.
@TonySinnettMarionettes
2 жыл бұрын
You are welcome, good luck
@illustrations.byozge
3 жыл бұрын
This is what I was looking for, great small tutorial! Thanks a lot 😊👏
@carlaschulz4217
6 жыл бұрын
I see that this was posted quite a while ago, but I just found it. Thanks for sharing. Loved the clown puppet and fun to see the different ways to attach the head. I love all things puppet, but marionettes are my favorites.
@Enki1977
2 жыл бұрын
I wish I had found your video earlier. Thank you!
@johnkoester7795
6 ай бұрын
Is it possible to transfer this type of method to a metal rod to a toy that basically made from stuffing and also fabric
@TonySinnettMarionettes
6 ай бұрын
I guess you would have to insert something into the fabric such as a block so you have something structurally strong.
@pistonforge
9 жыл бұрын
ty so much my friend..im gonna show you the end result soon of my project..very apreciate how fast you answer my question..i got all the information i needed to complete my marionette..thx again.
@crazyrees23
5 жыл бұрын
Does that wire from the head go straight up to the controller? How does that wire attach to the controller? I have watched a hundred videos and nobody explains that part.
@fordF500
5 жыл бұрын
I've been doing a lot of research into this type of puppet and you're right-there's not a lot of info on it. If you look at the 50-55 second mark you'll see that the wire that goes through the head does go right into the controller.
@pistonforge
9 жыл бұрын
did you make a video on how to make the control and use it..where goes the string on the control and the puppets etc..i like the one i see on this video compare to the one that look like a cross..i also see another king that look like a plane but i prefere this one you have..
@ludouglas1
5 жыл бұрын
how did you know where the cord was to line it up with the pin into the back of the head?
@vividius7951
6 жыл бұрын
it must be great to carve, I start off ok but I keep on making the chisel slip and chip off more than I want
@melissawhitley7589
4 жыл бұрын
if I was making a puppet from polymer clay, could I apply the same technique as shown in your second demonstration?
@melissawhitley7589
4 жыл бұрын
I have looked everywhere trying to find a solution for proper head movement and I am so thankful I found this video. I just hope it works. haha
@TonySinnettMarionettes
4 жыл бұрын
@@melissawhitley7589 Good luck. It should work nicely. If you haven't already sculpted the head then build over the cord (with a block or wooden ball attached to the cord first to stop it pulling out - even a nail through the cord and then sculpted over should work)
Пікірлер: 18