Since the motherboard was outside the server case anyway, I decided to just go ahead and replace the thermal-pads and -paste on the motherboard, I don't know why I didn't do that when I first built the server, but it was definitely necessary. Also, there was a thin thermal pad on the south bridge heat sink. I assume the chip doesn't need much cooling, especially now that there are a lot less sata hard disks connected to it. Plus, the thermal paste is probably better anyway, and I even used the good stuff.
______________________________________________________________________________________________
______________________________________________________________________________________________
CPU: Intel i7 930
MOTHERBOARD: Gigabyte GA-X58A-UD3R
______________________________________________________________________________________________
______________________________________________________________________________________________
LINKS:
My Gaming Channel:
/ @yukatigaming
My Twitch Channel:
/ yukati_gaming
______________________________________________________________________________________________
______________________________________________________________________________________________
MUSIC:
All the music in this video was made by myself
______________________________________________________________________________________________
______________________________________________________________________________________________
Негізгі бет Тәжірибелік нұсқаулар және стиль 2010 Motherboard: First time replacing the thermal-paste and -pads
Пікірлер: 6