Thank you! I just did mine saved me a thousand dollars. Except I used a utility knife heated the blade and cut the plastic like that made it look clean and jb welded the piece back in place and I used fishing line to snake the new sensor back in place
@apatriot1762
8 ай бұрын
Real sturdy duct tape, I like that
@ChrisJohnson-lp9fl
Жыл бұрын
Thank you! I was able to get it changed out thanks to your video. Saved me a lot of money!!
@sabatinoconstruction
Жыл бұрын
Thank you for this video, very helpful!
@mas121473
2 жыл бұрын
Nice video
@williamneff8166
2 жыл бұрын
I know this is an old post, but did you pull the old one out through the bottom? and if so, did the top stopper just push through the top hole?
@rodneykahane4994
2 ай бұрын
It goes the other way, push down from the top and pull it out the bottom. Pro tip - tie some wire or some to the end and then you can tie the new sensor to the end and pull it back through
@ahmedmustafa2145
2 жыл бұрын
Thanks a lot I will try for my 2011 silverado 2500HD And will let you know what is the result
@zachcoleman6285
Жыл бұрын
Were you able to fix yours?
@danielkaesberger7893
9 күн бұрын
Take out the airbag in the dash So much easier to get your hands in
@djgsell
Жыл бұрын
why not just stick the sensor in right up front and have the cord come out the front of the box closer to you?
@TeeP1987
Жыл бұрын
I was thinking that too. It doesn’t have to go back in the same place right? Doesn’t it just stick between the fins?
@justinstandifer604
11 ай бұрын
@@TeeP1987You can cut out the slot where the cabin air filter is supposed to go & put it there.
Пікірлер: 14